Gary Magin

UPDATE / SUCCESS After all the testing previously discussed, my focus turned to the Aquahot control board. This board is exposed and mounted on a bay panel on the pass side of the coach and shares the same bay as the liquid tanks and their access over on the dvr side. That bay is almost always humid, from flushing etc. On very close examination of the components on the board I noticed some minute(sp) green crusty corrosion on a few of the component connections. $500 later for a new board and the heating system is up and running. My question to any electrical folks out there -- The solder side of the new board does seem to have some type of conformal coating on it. Is it possible and permissible to apply either a silicone or a polyurethane conformal coating to the component side of the board??? The original did last 14 years, and I doubt I will be MH'ing in another 14 years, but just want to avoid another $500 ( or more ) Thank You all for the prior help. Gary Magin '09 Dynasty

UPDATE I found and replaced the 2amp fuse for the A/C control circuit and now the thermostat ( I only have 1 ) lites up and I did the reset to FF. I think the phone line communication is working, when I switch zone 4 to furnace, I hear a click in the hidden Z4 control module they hid in the wall behind the thermostat. At least I think the com is working from the thermostat up to A/C1 then to A/C2 then to the hidden board. I did only find two com cables and one connector in A/C 3 which is the end of the com circuit ( my schematic shows the com circuit as --thermostat to ACzone1 to ACzone2 to Zone4controller to ACzone3-- ) The zone 4 doesn't actually run though! I think this leads me to the aquahot 600 control board??? There are no faults shown on the board ( I pressed the reset button anyway ) The 30a fuse is intact and there is power to the board. The aquahot heats on electric ( I have not tried the diesel because it would smoke me out of the shop ) The aquahot engine preheat works and runs the circ pump. Eagerly await any suggestions on testing the aquahot for these conditions Thank You Gary Magin 2009 Dynasty

I had previously requested help under " FURNACE CIRCUIT WILL NOT RUN " because the furnace circuit wouldn't run. The A/C's did work. All voltages are up and proper, coach is plugged into 50A. I just completed the recommendations of checking and cleaning with alcohol all the phone line type connectors at all 3 A/C's, I also did the thermostat connector. I did one connector at a time and am sure there was no wire mix-up. The system seems dead now, the thermostat will not reset to FF it will not lite up at all. I have rechecked all connections at least 4 times, and have tried new female connectors, no results! I haven't opened the top cover of the A/C's yet. Could something have shorted out while brushing the connectors? Is there a fuse for the system somewhere? I did find the hidden Duo-therm panel ( 3109226.005 ), the fuse in it is good. Any and all suggestions greatly appreciated Thank you in advance Gary Magin 2009 Dynasty Yorkshire

Thank you, I did find them in the chassis battery compartment. Both were good. So now I have to find out why the interface / control panel is dead???? Gary Magin

For our 2009 Dynasty Yorkshire IV, the manual shows two loose wire mounted fuses that are called out to be near the solar charger box. I cannot find them, has anyone found them somewhere else, if so where? My control panel does not activate or show any voltages or solar activity. Thank You in Advance Gary Magin

Thank You Frank, That didn't work. The Aquahot fires by a different switch, It's the three zone heaters in the coach that won't come on Gary M 09 Dyn

On my 09 Dynasty with aquahot 600, none of the furnace circuits will run. I tried them individually and as pairs and all together. The coach is plugged in and batteries are up to voltage. We just returned from the south and used it without problems on the return 2 weeks ago. ( On a side note I did have it in at Cummins for trans lube/filter change, and they did access the OBD port for some reason, not sure that this would affect the system ) All other functions of the thermostat work like A/C, and fans. I tried the furnace circuit on ac elements heat and burner heat --nothing! Can anyone suggest where to start troubleshooting the system Thank You Gary Magin

I know it's very early, but with reservations at other locations very difficult to get less than a year in advance, can a date for the 2023 gathering be determined? We are in Florida now and wish to follow up after the gathering again with travel to the Keys and elsewhere in the warm! thank's Gary M '09 Dynasty

Is it possible there will be a bulletin board there for attendees to list any items or components for sale at the rally. I seem to remember this from previous rally's Gary M 09 Dynasty

Upon reviewing my build sheet for my 2009 Dynasty I find an optional equipment listing for " BLUE-TOOTH LINK IN COCKPIT ", and " DIGITAL CELL ANT & WIRING ". My questions are What, Where, and how are these accessed? Any help would be greatly appreciated Thank You Gary Magin 2009 Dynasty Yorkshire

Does anyone know of a GPS app for an Android or an Apple that would take into consideration weight and height of an RV in the routing program

I would like to get some input on what the best type of coach De-humidification methods would be best when storing the coach in northern Florida during the winter. It will be plugged into power. Just leaving vents open has resulted in mildew.

I am having trouble with the entry steps on my Dynasty. They are the two steps that are slide out on drawer type slides. After driving thru a torrential rain storm hast fall they stopped working. I traced it to electric problems with the step electric module that must have leaked water. I replaced the module, cleaned and lubed all the arm pivots. The steps worked fine when the work was completed The very next day, they stopped working! I downloaded the manual on the Lippert site, but I didn't find any info to help, other than to trouble shoot the electric again. Has anyone found any adjustment tricks or techniques? Thank You Gary M 09 Dynasty

I have not found a way to search for info on the new site. I specifically need the phone contact info for REV, but would also like to see if I can get to the prior database.

Where can I find out the paint codes for my coach It is a 2009 Dynasty / Yorkshire Thank You Gary M