allphase8

I have been using Elite since Eric was working at Monaco. I know them well. They do excellent work but this remodel is out of the scope of what they offer.

So my coach is at Amazing Creations having almost this exact work performed. The pictures I am receiving of the work in progress looks very good. They are located in Junction City, OR so may be farther than you care to drive. Scott the owner was a Monaco employee for several years back in the good old days and knows Monaco’s well.

Sorry, thought you were coming from San Diego. Should have read more closely.

I have driven that route many times. The grade down from Julian is pretty tough. I would suggest this alternate route which is much better IMO and avoids the climb up to Julian and down from Julian. When you get to Santa Isabelle go left on 79 I think it is and go several miles to S-2. Go right on S-2 and that connects with 78 after the grade from Julian. Go left on 78 to Ocotillo Wells. This is a much better route.

So when you remove the main circuit panel cover below the panel is a board with relays on it. There is a 5 amp, i believe, fuse there that if blown will disable the display and the function. I would check this fuse a mini auto as I recall.

Do drive that or is it a show engine compartment. Disgustingly clean and shinny. (:o)LOL

Not a break expert by any stretch. But have had to replace rotors on my Camelot a couple of times. I do not think those surface cravings are a killer. You need to be concerned if the crack goes through the rotor. JMO.

NO

I use Silverleaf VSMPC and monitor on a laptop along with my Route Planed Nav system.

2006 Monaco Camelot The shower diverter does not allow me to turn the knob to adjust water temperature. Have taken it apart an still not sure how it works. Need advice and what to do to get it to function. Maybe a P/N and manufacturer. Thanks Ron 2006 Camelot 40PDQ

Just got the parts to run the 10G wire today. A chore forr after the rain quits in the next couple of days here in sunny So Cal.

Still trips OEM circuit breaker if run more than a couple of minutes.

That is the way I would like to do it as the New Sanicon is already wired through the old switch to the switch box on the new sanicon. Can you provide more detailed instructions on how to do this? My electrical abilities while limited are not nonexistent. Is it a matter of changing the VF4-1511 relay that is currently there with a different relay? If so is there a part number for a replacement relay. Thanks Ron

Thanks for everyones thoughts and suggestions. Purchased the items to run a 10a power and ground to the new Sanicon. Will totally bypass the existing wiring to the old Sanicon. Ron

Got this on Amazon for the larger hose on for the Sanicon 600 i recently installed. Went through several hoses on the old Sanicon. It looks like it will work to protect the hose. https://a.co/d/1qN9cjP Ron