Jump to content

rpasetto

Members
  • Posts

    327
  • Joined

  • Last visited

  • Days Won

    6

Community Answers

  1. rpasetto's post in VIP Smart Wheel trouble was marked as the answer   
    I recall doing this years back.  I just cut off the wires mentioned below.  (However, if you remove them from the connector you could always reinstall them if you decide to go back to 'factory'.  There is a tool used to install  & remove pins from these connectors.)
    Remove wires p1 and p2 from connector J12 and also remove wire p6 from J11 (Wire from headlight switch).  Connect the p6 wire from headlight switch to the coil of an 87 type relay (see diagram);  pins 86 and 85 connect to the coil so you could connect headlight switch wire, P6 to 86 and 85 to ground.  Pin 30 of the relay should get the 12v power via the headlamp fuse in your front electrical box, that's p1 if I recall, and p2 would connect to 87 to power headlights.  I strongly recommend fusing both circuits: the coil (85-86) and power (30-87) just in case there's a short somewhere.
    Hope this helps.

×
×
  • Create New...