Steve Hepfer

Thanks to all for the input. With the help of a good friend we disconnected almost everything wire by wire. Still not sure why my meter kept reading 28V but once we reconnected everything I pressed the ON/OFF button on the inverter it reset and for now all is well.

Scotty: For Item 4.4.1 Line 1 above, when the coach is disconnected from shore power there is nothing. When pressing the ON/OFF button without shore power there are no messages and no LED light on the Inverter reset button. When I am connected to shore power and press the ON/OFF button on the inverter the green LED comes on but does not go off

Some time last night I lost all power to our 2008 Diplomat 36PDQ. The Magnum Energy display board inside has a solid red fault light on and a blinking green light for the Charger. The display panel says "Dead Batt Charge DC 0.0V 0A". If I press the inverter button I get a message "Low Battery DC 0.0V 0A". I am plugged in to 50 amp shore power and have 117V on one leg and 118V on the other. Need help figuring out how to restore power.

I am replacing the front AC on my 2008 Diplomat 36PDQ. Checking to see if anyone has the Dometic #3313107.107 conversion kit to go to the 5 button thermostat?

Still waiting on a response from M&M

The fix was a bad control board for the Intellitec EMS. New one ordered

I am having a similar problem even though slightly different. I am plugged into 50 amp shore power and both legs are reading 118 volts at the Progressive Surge protector. I too have the blinking light syndrome along with a constant clicking sound from the electrical panel. The Intellitec panel says that I have 30 amp even though I'm connected to 50. There is one 20 amp breaker I can turn off and the clicking goes away however the Intellitec display does also. I have replaced the breaker thinking that may solve the issue but it didn't. I am starting to think that the Intellitec board may be bad. I could use some help hear. TIA Steve Hepfer 08 Diplomat 36PDQ

Check your fuses. I had the same issue and it turned out to be a blown blade fuse

Check to see if any of your gfci outlets have tripped. Also check to see if it will run on propane

Garry - I ordered it from Pressure Pro

I have a 36 foot Diplomat and had to get their antenna to boost the signal to the toad. Mounted it underneath on the frame

I too have the Cummins ISL-400 and agree with your comments about the exhaust brake. I mostly use mine when I may need to stop quickly. It also saves on the brake pads. My sweet spot is about the same as yours however I am getting slightly better fuel mileage. I typically use the cruise control with the Allison in Economy mode so it shifts at a lower speed. I typically hit 6th gear at 57 then will set my cruise. Once done I will then back the cruise down to 55mph. I typically get 10.5 mpg just letting it coast along on the interstate. I reset the mileage at each tank fill-up so I can monitor the mileage per tank. We just came home from a trip where we left Florida and went to Pigeon Forge, Tennessee. Each tank fill-up was about the same at 10.5 mpg except our last fill-up in north Florida. Driving from north Florida to Sarasota we got 11 mpg. Simply put the ISL-400 is a beast and perhaps one of the best engines on the road.

I'm not sure if they use the same parts or not but you might try Wade's at Lazy Days in Seffner Florida. They made our slow moving shades for us but I think they used a different fabric. The moving parts might be the same. Good Luck

Does any one have the part number for the entry step on a 2008 Diplomat 36PDQ? Could also use a link for video for replacement?