Jump to content

4rickyg

Members
  • Posts

    110
  • Joined

  • Last visited

Required Information

  • FirstName
    Rick
  • Make
    Holiday Ramber
  • Model
    Navigator
  • Year
    2005
  • City & State
    Ocala Fl.

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

4rickyg's Achievements

19

Reputation

  1. Thank you guys. Going to look into it today.
  2. My microwave looks like it has loosened up or dropped some. I can lift it up and wiggle it. There is about a one inch gap between the top of the microwave and the bottom of the cabinet. How do I remove it to see if I can tighten it up.?
  3. It was giving me problems before I decided to do the maintenance. That could have been why it was cutting in and out on me. I think the voltage was fluctuating.
  4. Thank you, Tom. I got it figured out. I had 13 V at the 25A fuse in the rear run Bay. But the 10 gauge black wire next to it That supplies the power to the aquahot looked burnt and was loose. I took it on and off a couple times and then had 13 amps to the control board. Think I need to cut the spade connector off of that wire and install a new one for a better connection. Also when the Motor was running. And the burner ignited I was getting a little over one vault drop Add to control panel. Do you think that is normal? Thanks again to everyone for all of your replies😊
  5. Yeah I figured that! Not really sure where to go from here?
  6. I checked the big red wire Coming in to the aqua hot motor it is reading 7.16 volts
  7. Aqua hot 600 D. Unit was blowing a lot of white smoke And shutting off. I performed the annual service of filters new nozzle and cleaned all the carbon build up. After reassembly it will not fire up. When I turn on the rocker switch inside of the coach , it does not light and the unit does nothing. Looking at the panel the red low voltage light is on. I hit the reset button. It will go out and then come. Come back on when I try to start it. Checked all the fuses I could find. some in the front Bay some in the rear Bay. They all seemed good. Also battery voltage is 13.3 house and coach. Any ideas what to check next? Thanks Rick
  8. Got it😊 It was the number two 20 Amp fuse. Guess i missed it somehow with the test light. One more question are those fluorescent lights? 12 V? Thank you so much for your help..
  9. This is the fixture and the wires it plugs into. Only some of the switches are working. When I turn on the first one,rope lites all the switches should light up. They are not. Also base board heater is not turning on.
  10. Just put the meter on the white and black wire did not get anything. Not quite sure what you mean about the extension cord. I have a cord with alligator clips on each end. What do I do with that? I just looked this coach does not have any g f i's in the bathroom?
  11. I used a test light on the fuses. And I used a tone detector on the 110. I could go back in with the Volt meter and see if I get anything on the white and black wires.
  12. 2005 HR Navigator. Was going to change out my fluorescent lights above the sink And the pantry. When I removed them I found No Voltage at the black and white wires. Also a problem at the switch cluster in front of the sink. I lost some of the operation there. The switches do not light up when I turn them on. No rope lights no baseboard heater. But the ceiling lights the aqua hot diesel, the halogen lights and the water pump all comes on. All switches and lights in the front of the coach and bedroom are working normal just the kitchen has the problem. Also, the 110 outlets are all working in the kitchen. I've checked the breakers in the bedroom. The fuses in the closet and fuses in the front and rear run bays. I can't seem to figure it out. If anyone has some ideas I would appreciate it. Thank you
  13. Thanks don it's looking like that's what i'm going you have to do.
  14. Yes eurton is the place I was talking about. No they had not told me what happened. It does have four thousand hours on it.
  15. Generator died on my trip to OKC. Giving me a 27 code. Took it to Cummings OKC. They said needs a new stater and rotor. Told them to go ahead and fix it. They said they could not get the parts and that they were 6 months out On the parts I need!!! I can't find the parts online , wondering if anyone else had any ideas? Roter 201-3506-s3 stator 220-4647-03. Onan 10k spec c. Found a place in California that will rebuild them. But I can't get my old one to them and back in time for my trip home.
×
×
  • Create New...