welleking
Members-
Posts
28 -
Joined
-
Last visited
Required Information
-
FirstName
Wayne
-
Make
Monaco
-
Model
WINDSOR PEQ
-
Year
2006
-
City & State
bremerton
Optional Information
-
Brief Bio (Optional)
RETIRED DOD marine electrician. RV tech after
-
Profile (Optional)
been a mechanic , electrician, plumber, RV tech. 100 % Disabled VET.
Recent Profile Visitors
The recent visitors block is disabled and is not being shown to other users.
welleking's Achievements
5
Reputation
1
Community Answers
-
The AGS was my thought exactly, but the why has me perplexed. My inverter is indeed a magnum and the low volt start is set at 11 volts. The voltage reading there was 12.5 when I started the generator and turned on the block heat. An hour or near that I shut off the block heat after starting the engine the alternator light flashed and i shut down the generator..I THINK. I stopped at a rest area 70 miles later and it was running. shut it off for sure this time drove another 2 hrs and it was running. At this time I had the POs by pass switch was open. This was built 6 years after I tried to retire from RV repair and I had never heard about VADIL nor ALADDIN. I installed HEART units and had 2 in my executive. The major question in my mind is what could be using the power at that rate.. I can believe my big boy combiner IS BAD. That will change soon. should I add an ammeter shunt to help find the problem since I can only read my clamp on really close.... WAYNE K 06 WINDSOR
-
welleking started following Worth a laugh , 400 ISL - Faulty Intake Manifold Temperature Sensor? , 2007 Dynasty wiper arm replacement and 6 others
-
I fear a temperature sensor in my system is screwed up. My 06 windsor is new to me but suspect that the previous owners may have been on this site too. Anyway the scan guage shows a voltage reading light the grid heaters are cycling while driving down the road. This would drive the alternator and its installed regulator nuts..the aladdin jr is showing an almost constant 13.5 to 13.7.. neither is high enough to suit this retired electrician/ mechanic. Any help or input welcomed. Wayne E 06windsor
-
2007 Dynasty wiper arm replacement
welleking replied to D.Ellison's topic in Body, Awning, Roof, Slides, & Steps
I've been digging deep for good info on arms for my new to me 06 windsor. Nothing I've seen is rightand its Saturday whole dammcourseed weekend to turn it over in my mind. Of course I was told they were repaired when I picked it up. Who ever the previous owner was I'd sure like to talk to them, no complaints just questions. -
Intellitec Support - CPU and Keypad backups and restores
welleking replied to pwhittle's topic in Audio, Video, & Electronics
Mine Are all working fine now I do not that to remain so. Add me to your list. On another item I bumped the power button going out the door and shut down all power from the salesman switch yesterday. Today I removed the fuse from that switch eliminating all possibility of that happening again UNTIL I reinstall that fuse. -
rear tires rubbing on H frame
welleking replied to Mike Farquharson's topic in Chassis, Handling, Tires & Brakes
I had the same thing happen to my 95 exec. Actually did it my self by allowing the tire shop to remove a spacer that had always been between the hub and the wheels. -
it is a PEQ and it has the VALID also. I had to manually level today since I wanted it lower than valid wanted it. The step motor is bad and needed to block the step in place. next problem since the water heater now works is the aria electric toilet. Ifear it is going to have to be replaced. I finally got some time with thev owners manual today. The messages about the sildes were welcome news since I just located what info I have. THERE should be no EGR until 08 I do not believe. There were lots of changes after 07.
-
I traded my 95 exec for an 06 windsor. Holy smokes. I have posted so little for many years I have forgotten how and where to put this info. The differences are astounding and I have many bugs to work out. I was told to extend the slides before leveling is that correct? It only has 56k so it was stored quite a bit and this 400 is thumping a bit. Hoping hot shot will do away with that. Wayne E
-
WARNING!! I40 IS A DANGEROUS ROAD
welleking replied to wmh4805's topic in General Motorhome Discussion
No it is because of the number of wrecks resulting in serious injuries or death. -
WARNING!! I40 IS A DANGEROUS ROAD
welleking replied to wmh4805's topic in General Motorhome Discussion
Also take heed that US 93 is rated as 1 of the most dangerous hiways in the country from Las Vegas south. I have not traveled the new INTERSTATE that is supposed to improve safety along that route. Wayne K 95 exec -
I replaced that supply line with a longer 1 routed away from the manifolds heat. At 158000 plus miles and lots of LEARNING situations i have replaced and had several turbos replaced. The last 1 replaced was a new china made cheapo that the v band clamp area snapped OFF crossing some rough road in Las Vegas. the china made copy was under 300 bucks. Replacement unit was at the time the last new holset in the U.S..right at 800 dollars noon the next day delivery, AND I had to explain the clocking procedures to the mechanics. Wayne K 95 exec
-
looks like Ive missed it. cannot find it there welleking@gmail.com 360 271 8007
-
I would like more info on who has what or sale WITH IN THIS GROUP. I have been looking hard for a nice used coach and have been told they would allow me $8695 for my 95 Exec. My daughter wants this coach but I fear she would shortly be over head and be far better off with a trailer or 5th wheel. At 79 I will not be around long to help her with things she would have to be taught about this coach. She just needs something simple to move into.