Jump to content

samchev

Members
  • Posts

    2
  • Joined

  • Last visited

Everything posted by samchev

  1. Jim J, Thank you for ur reply. I also have a pdf version of the schematic that i was able to download off this site. I attempted to zoom way in and use the ctrl 5 trick and had no luck in improving the resolution. Tried to do this using both adobe and microsoft edge. Do u prefer a different program for viewing the diagram or have access to a diagram with better quality for an 07 camelot ? thanks for any assistance
  2. Have 07 monaco camelot. Started this spring to get out of storage and engine started and ran then quit after about a minute. Found Fuse in electrical box under drivers compartment blown. Fuse is 10 amp and labeled as "key" and located in electrical box "Monaco 1". Installed new fuse and was able to run for about half hour and fuse blows. Replaced several times during testing and seams to blow intermittently with no rime or reason. Some times running a min or two , sometimes half hour. When fuse blows , unit is dead in water, just like key has been turned off. Performed amp draw test on circuit and with engine running and all electrical loads turned on was only able to draw a max of 1.5 amps. Reviewed electrical diagram downloaded off this site and able to locate the fuse on the diagram, but unable to zoom the diagram to follow the circuit. Have visually inspected the wiring in the box, to the drivers compartment , and under dash. All wiring looks fine with no spots showing signs of rodent damage or wiring shorted. Monitored amp draw while disturbing the hareness trying to find a short to ground or any issues and amp draw is maintained at 1.5 amps while wiggling all sections of harness. UNlikely caused by moisture , unit is stored in clean and dry facilty when not in use. Has anyone had experiece like this? Any advice at all will be greatly appreciated.
×
×
  • Create New...