Steve's Bus

Mine are in good working order. I may just paint mine. Thanks for the response and good luck on the sale!

Hello 

I just had a question? My mirrors look like yours and I have been thinking of replacing mine. I have already replaced the arms and mounts. If you don’t mind me asking where did you find replacements and cost .Thanks Steve

4 minutes ago, Gary M said:

 

We lost Moose, Maggie’s older brother in January 2020. Now to lose her too is gut wrenching. But we still have Milo. The only problem is I need to out live him. Can I make it to 85.

4 minutes ago, Gary M said:

 

We lost Moose, Maggie’s older brother in January 2020. Now to lose her too is gut wrenching. But we still have Milo. The only problem is I need to out live him. Can I make it to 85.

At least you still have Milo! God willing you will make the trip that’s the best we can hope for! Good luck ! Give Milo an extra treat tonight from Buddy and I. Again so sorry for your loss!

So Sorry for your Loss! 
This is my Buddy he’s 8 . I don’t want to even think about that Day in our life when he’s gone. 

Mine is behind the right side ( passenger side ) headlamp and hard to get to. Mine is a 2001 Signature.

Hi Tom

I have a 2001 signature. The problems I have had with this clock has been resolved by removing floor of cabinet behind clock.  Track wires from clock to connection. There are speed nuts on them, remove power wire for 10 seconds reconnect wire, it resets it I guess but has resolved such problems two times in the five years I have had my bus. Hope this helps ( Good Luck )

Steve

From what I understand it makes no difference where slide is positioned upon removal. Personally I removed and reinstalled mine with slide  1/2 way out.

Hope this Helps!

On mine one end of the roller shaft will depress inward, but mine had set screws tightened down against shaft and would not move.

Also because of the opening size being very close to the roller size it would be impossible to remove roller without removing at least one end of the mounting brackets.

The picture that shows his roller , is just like mine and the roller in my link will replace roller only. Reuse his brackets!

I have been told Monaco went to your design roller with a single bolt adjustment to help to eliminate the roller   damaging the nylon cover. This being caused by unequal load on each end of roller by miss adjustment. 

I am in the process of replacing all 4 of my Slide rollers on my 2001 Monaco Signature. I purchased my rollers from https://shop.findmyrvparts.com/monaco-rv-slide-out-roller-clear-cover-08408530-p/190255.htm

The roller you have pictured is the rear one under the sink. If I’m correct you just remove the 2 3/8 bolts and the roller and brackets lift straight up and out. Once removed you will see there is a Allen set screw in bottom of bracket
Once you remove roller make sure there is no damage to the floor, check floor in slide extended position. 
Hopefully this will help!

Good Luck