Bootlegger 659

What coach are you working on would help many. On my 05 Diplomate both my fuel filters are located on the drivers side in the dash air conditioner fan compartment behind the drive tire. you need the butterfly key to access this compartment.

Thanks Jeff, for supplying the links for these simple upgrades! Makes completing these task's so much easier. 

Bill, I just replaced my intake temp sensor.  It did throw a stop engine code and put it in D-rate mode. An insight software expert from another site said he had never seen that before In his entire career.  Go figure, it happened to me. After replacement all things are normal. So you are not the only one! This was on a 8.8L ISL 400.

Huge undertaking... let me clarify,  putting the flooring down is the easy part. Preparing the subfloor was my challenge.  I removed my tile and carpet. Also I found two areas with severe water damage. After everything was repaired new subfloor down it went pretty smooth.  I'm 64 I wont do it again!!

I just finished reflooring my 05 Diplomat 38pdq. I used vinyl plank. Turned out beautiful. But... it was a huge undertaking, lots of research on materials. Ernie and Brent Ekberg were great resource and inspiration. It will test your skills. Good luck. Have any questions pm me.

Ali, take it out run down to the parts store and they will match it up. Prolly has some rust or foriegn matter in it. 

53 minutes ago, Dr4Film said:

Two places, the House & Chassis Disconnect Switches plus the Battery Cut-Off Relay are all places where there have been multiple failures.

What brand of disconnect switches are currently in your coach?

Where is the cut off relay located on an 05-09 diplomat? 

Just put on new steer tires at Pomps tire service in Blue Grass Iowa. Micheline XMZ 275/70R/22.5 dated 5/22. Out the door $1540.00. Sold my casings to a local truck company for $160.00. I'm happy. Also put centrimatic bead balancers on $196.00. Thought I'd try them.

Your shore line should lead you into your transfer switch.

Best I've found is Boeshield T9 dry lubricant. 

Ok thank you Dr4film. I believe I have that black box with red light. Not sure about the flume sensor, but I assume they go together. I'm going to check.

How would one determine this black box/high temp flume sensor?

You may have fixed your problem,  but on my 05 diplomate my 12 volt fused feed comes from a control board located on the back of the fridge. Go outside to the refer access panel, open and inside there is a black plastic cover (box). Take that cover off and you will see the fuse. Real treat to get to. Mine is located in the upper left behind the access panel.