Radar22

I’ve used RV Glass Repair services in Greensboro NC. They have patterns for many makes and models. Just ordered passenger door window from them. Super nice people to deal with. 
 

good luck 

Hi Pete,

I have a 2000 Imperial. While I don't have the battery compartment schematic. I have attached the house & 50 amp wiring diagram should you need for future reference. If nobody else has a wiring diagram I'd be more than happy to send a picture of my battery compartment hookup. Let me know. 

Marc 

Schematic 120VAC 50A w-inv - 38011035.pdf Schematic House 12V - 38011038.pdf

Hi Jim,

Had the same issue but my coach would blow black smoke and come to a grinding halt. When cooled down I could proceed but not very far. Had repair tech telling me it was bad diesel and most likely algae in the tank. Finally after treating gas it was not the issue. Took to Cummins service center and they discovered a leak in the charge air cooler. Had to have the charge air cooler dropped, and re-cored. Had radiator re-cored at the same time figuring if both were dropped might as well do radiator. Fixed the problem but as you can imagine it was a very costly endeavor. 

Interesting thoughts. I bought a leak tester and will continue to probe. Thanks 

Hi Tom,

‘Thanks for the reply. The tank valve has not been opened for a few years so I don’t know where it could be leaking from. I did purchase a new regulator and will install but don’t know if that’s the source of the leak. I will open valve and do soapy water test. 

Hello,

I consistently smell propane outside coach with the valve closed. I did a soapy water test to see if there was anything bubbling and couldn’t find anything. Should I do same test with valve open? Any suggestions? Thanks 

I replaced my original with a Natures Head composting toilet. 

I had the 3m film on the front of the coach and ended up using goo gone with many plastic scrapers, and also power washing it off. Wasn’t easy but finally got it off. 

Quote

No but you may be able to get a remote box to avoid running wires to main box. 

Here ya go Martin,

RV Glass Repair Services

510 N. Spring St

Greensboro NC 27401

336-273-7661

I removed glass, buffed it till my hands were sore, tried every glass scratch remover, machined it with 4000 grit sand paper, and nothing worked. Once glass is etched it’s impossible ( in my mind ) to bring it back. I contacted a place in NC who has an amazing library of glass dimensions and bought replacement glass. Not cheap, and Fed Ex freight was $$$. 

I would’ve thought it would be more expensive in NY than Florida. I would check out Liberty Mutual. I’m paying under 1k in NJ but obviously it depends on what type of coverage you’re looking at. 

I wish there was a chassis manual for Roadmaster around. As far as Monaco is concerned I contacted the people at REV a few years ago and the only thing I was able to obtain for my 2000 HR was the wiring diagram, structural diagram, and paint codes. If you ever find a manual please let us know. Good luck with your coach ! 

Maybe Elon Musk will develop the auto pilot technology for motorhomes. I’m in ! 

Could not locate it in the generator bay. Anybody else have this configuration that could pinpoint resistor location. Thanks 

I agree with Bill. 8.3 ISC is probably what you have. Cummins has service distributors all over the country. To be sure you may want to give one of them a call. Good luck with your coach ! 

BTW- I ordered quite a few led lights from a company M4 LED. They have a large selection of lights for RV’s. very knowledgeable and great service. 

Does anybody know why this light comes on the dash. Just had coached checked for alternator issues and possibly a  parasitic draw. All checked out Ok. thanks 

I went to a local locksmith and he had them in stock. May want to try one. It was the Southco brand. 

Found the following in the generator bay upper left. Is this the dash fan motor and squirrel cage ? Where would the resistor be. Thanks 

I may have gotten lucky as I found the following In the generator bay. Is this the motor for dash fan ? If so, where would the resistor be located. Thanks in advance for any advice. 

Thanks for posting the pictures. Only a one Lite beer job ? Looked like a 6 pack job to me. 

Thanks Dan. Maybe easier to build an external cage hamster powered😄

Merry Xmas 

Nick,

‘Wishing you gods speed and hope everything works out for the best !

Marc 

Noted. Thanks