sg47619

8 minutes ago, timaz996 said:

On mine I have to push it once firmly and immediately let it go as it works as an on off switch. If I hold it, it will do what you’re talking about.

Ok I’ll try that tomorrow, thanks

9 hours ago, timaz996 said:

It is your VIP system. If you push the CC button on the steering wheel it will shut them off.

It shuts them off as long as I hold the switch, when I release it they come right back on. 

21 minutes ago, Dr4Film said:

Yes, will work on three zones and it is both 120 VAC for the twin Electric Assist elements and 12 VDC for the diesel.

21 minutes ago, Dr4Film said:

Yes, will work on three zones and it is both 120 VAC for the twin Electric Assist elements and 12 VDC for the diesel.

Thank you, lm having trouble with my Aqua Hot now. I made really look into this now

I have a 01 Monaco Dynasty Jack.  I’m hooked up to shore power at my house, went out after the storm yesterday evening and the headlights were on, I checked the switch and it was off the key wasn’t in the ignition. Has anyone had this happen? I had to shut the kill switch off in the back panel to get them to go of. 
Thanks in advance 

My question to this would be will it work on three zones and from what I saw it’s only 12V. Thanks for posting 

On 6/27/2023 at 5:42 PM, djlgnd said:

realy could use these to remove my unit in my 2003 Monaco

thank you for these helps me out greatly

Thank you for the files, after my trip in August I’m going to change mine. 

2 hours ago, Georgia Mike said:

Use a pdf app

Thanks

2 hours ago, Patrick said:

I recently had to replace the AquaHot AHE-100-01S tank in my 2002 Dynasty.  The copper fresh water coils had developed a leak.  I had noticed a small amount of water collecting in the service bay for some time.  Eventually the leak increased and I had to turn off the water pump when water was not needed as it would cycle continuously to maintain pressure and a puddle formed below the AquaHot.

I owe a tremendous amount of thanks to Vito Adragna for all of his help with this project.  He patiently answered my emails and text messages.  Without his help I would have been lost.  I also want to thank John and Hanna Carrillo from HeatMyRV.com for their help and the replacement tank.  John is busy but he did return calls and text messages when I needed him.  Fortunately for us replacement tanks are available.

I could not find any instructions on this procedure, so I have attached my notes and photos so that it might help someone else.  Use at your own risk!  

The filling and pressurizing procedures are different from the manual with the new non-pressurized tank.  It worked quite well.  Took me about 16 gallons to fill the system.

AQUAHOT REMOVAL.pdf 11.28 MB · 20 downloads AQUAHOT SKID ASSEMBLY.pdf 8.31 MB · 17 downloads AquaHot Skid Disassembly.pdf 16.32 MB · 14 downloads

Thank you so much, how do I get them to open on my apple IPad?

Mine is the same also, and I have to have the handle pointing north and the front pointing south to get the satellites. Not sure how that will work being installed on the roof. I’ll be waiting to see. Good luck 

23 minutes ago, Steven P said:

I changed out the PO's large, 2006 in motion satellite that wasn't working. Just threw it down to the ground when I unhooked it.  One guy at the storage unit was startled.  I guess a warning would've been nice,  lol.  He was nowhere near me, but it was loud.  I covered those holes w eternabond and dicor. 

Thanks, that’s probably what I’ll do

Mines the same as Jim Js the relays are in the passenger side rear compartment, I go my relay from NAPA and bought a spare to go with it. Good luck. 

Just now, sg47619 said:

Mines the same as Jim Js the relays are in the passenger side rear compartment, I go my relay from NAPA and bought a spare to go with it. Good luck. 

You should also check the safety buttons on the doors to make sure the are making contact. 

37 minutes ago, 96 EVO said:

Bottom insulation may be saturated and some water escaping there.

Ok thanks 

44 minutes ago, Bob Blackmon said:

Prior to new boiler panic, with the unit running, determine if it's hot or cold water.

It’s warm, not hot  like comes out of the faucet 

1 hour ago, Dr4Film said:

Not good news. You most likely have an older Aqua-Hot with the internal fresh water coil inside the boiler which has sprung a leak.

Yes it’s a 100-00S model that sets in the moof the basement, I have a quote of 11.6 for the new 600 model and that’s not installed 

Just now, sg47619 said:

Yes it’s a 100-00S model that sets in the moof the basement, I have a quote of 11.6 for the new 600 model and that’s not installed 

Middle not moof 🤦🏻‍♂️🤣

3 hours ago, willbo777 said:

Take the cover off and be sure you don't have a fitting leaking.  The hole where the exhaust comes out is at the bottom and where any leakage ends up.  Keep your fingers crossed that is what it is.

Took the cover off can’t see any hose’s or valves leaking there is some water coming from the inspection plate where the heater element goes in. 

Getting ready to take it apart now, we shall see. 

8 minutes ago, vito.a said:

Because the older Aqua Hot design has the fresh water copper piping wrapped around the outside of the boiler tank.  The lower tubing is only an inch from the exhaust port and they develop leaks.  

Sorry.  I just replaced our boiler. 

I hate to ask how my are we talking about. 

Why would there be water coming out the hole where the aqua hot exhaust comes through the floor of the basement ?

This is what mine looks like. I now have bigger fish to fry, I have water leaking  from around the aqua hot exhaust pipe, I just got it out of its bedroom and was getting ready to leave Saturday looks like plans have changed. Thanks everyone 

I think I know the answer but why would there be water leaking out of the aqua hot system where the exhaust pipe comes out. We we’re leaving on a short trip Sunday 

8 minutes ago, JDCrow said:

The big dome? Mine is gone, they just left the mounts there so there were no holes to get leaks. 
 

On the traveler. My wires do not go straight down, they go out. I doubt  there is a hole under mine. Where are your wires? 
 

They make a base plate to go on to help mount the traveler. If you don’t already have it, you could use it to cover over any ring you find 

My wires run out from under it to the front of the coach and down through the roof just back from the windshield. 

I have a 01 Monaco Dynasty Jack, as anyone removed the large satellite off the roof of one of these ?

I’m from southern Indiana and around here I don’t believe it would pay off with the extensive training and the amount of coaches I see in my area. 
2001 Monaco Dynasty Jack 38

Thanks for all the info, you all are always very helpful 

Thank you, I’ll try this.