mello1

12 hours ago, John C said:

@zmotorsports Hi,Mike,

I followed your post almost religiously and it helped me a lot to change my 10 airbags.

I made just one change as following:

I bought one pair of 24 ton jack stands (rear) and one pair of 12 ton jack (for the front), but I could not find jack stand that are long enough to directly in contact with chassis, I can stack up jack st      and 10 pieces of 2x10 but I don't feel very safe, so here is what I did, for the front I cut a pair of 6x6 as a jack stands, that turned out to be very strong, on the driver side, there is no space on the chassis that I can put 6x6 there, so I cut above 2 inches from the 6x6 , make it 4x6 on the top, on the bottom it is still 6x6.

for the rear, I use 4x8 because the limited space.

I am doing it very slow, and I am made a decision to  change the 10 shocks. now it is the 4th day, the coach is on the 4x8 and 6x6, looks very solid.

 

Thank you so much your post, without it I won't even know where to start! 

 

1 minute ago, mello1 said:

 

John, I think you need to rethink your approach to this project.  Your desire to support your coach from the highpoints of your frame along with the locations shown in the photos is a death wish.  Truly an accident waiting to happen.

I found where the 1/4 inch line from the back of the refrigerator was under the refer in the furnace space. there was a 1/2 in blue waterline there with the shut off valve. so I replaced the entire 1/4 inch line..all is well  I want to thank all of you that replied.

thanks Jim for your input

I have a 2002 Endeavor, and my water feed line for the norcold refrigerator is brittle and broke near the control valve. My question is where the feed line is connected to the water system. I could splice in a repair but I would prefer to replace the whole hose.

Thank you for the Info both tips and parts. Your efforts are greatly appreciated.

Great job....I'm sure my unit is in need . whats your opinion of shocks....also any experience or opinion on the Blacktech RML 79376 air bags?