stuff4sale09

So I decided to install a washing machine, do not like the front loaders, had one and it leaked all over the place in older coach. Also did not want to give up a whole closet of space. So i seen this LG Sidekick at Sam’s club , figure i would try it, they have a 90 day return on appliances and for under $400 why not. Yes it is small, so i tried and washed 3 beach towels perfect, and then tried 2 sets of clothes again worked perfectly, 3 fleece puppy blankets also nice and clean with no vibration and can’t here it running ( mind i am a little hard of hearing 😉 ) 

i have NO affiliation with LG or Sam’s Club except a club member.

just wanted to document and give folks a option to a  smaller space saving washing  machine, 

Hello Barry

Very nice coach

do you have any current interior photo’s ? All photo’s with shower except one ( with vacuum) for what i can see has the original fiberglass shower body in them, so i am assuming they are either stock or older photos.

also location of coach , Thank you

Red 1157 bulbs on e-bay and Amazon

Ok hello again been doing a lot of research, and seen my post has been sidetracked, going in different directions.

This was my original issue, and yes i have many 😉 . As you can see in the picture (using Michelin as a example only)

275/70R22.5 LRJ X-multi-Z single 6940# @ 131 psi , Dual 6390# @ 131 psi, this should be a 18 ply tire

275/80R22.5 LRH X-Line Energy-Z Single 7160# @ 120 psi, Dual 6610# @ 120, this should be a 16 ply tire

My ACCURIDE rims state max 125 psi, and no i will never overload my rig, would i be better to go with a higher load at a lower psi (275/80) or going with a higher load rating (275/70) that i would not be able to because of the higher psi is more then rather Rims.

Again Thank You All. 

Thank you all for your knowledge , i guess in the back of my mind i was concerned about going up in tire size , worried about front tire rubbing on fenders, and also rear dual spacing issues. 

Now with the info i can look into other tire options (sizes), speed odometer readings not an issue, my gps keeps me in check :), she yells at me when i go 5 MPH over speed. 

My concern is getting a more harsh ride with a higher psi for the same weight as per tire MFG weight / psi chart. But i may have found my answer thanks to all reply’s , the Bridgstone R205ED 275/70R22.5 tire has a max weight of 7000# at 120 psi. Just have to do a little more research On this tire. Hope they are a good tire and will work.

another question is there any location i am in Ocala, Florida area that i can get 4 corner weight, maybe someone knows of.

again thanks for all info.

Thank you Tom and JDCrow, this is where I get a bit confused Tom, so for the same weight Goodyear vs Michelin just saying (Toyo I do not see steer / all position tires in my size) goodyear would be 115 psi @ 6510 and the Michelin , continental, firestone etc. would be at a 120 psi for the same 6510# weight, 

not that i am ever close to max load, just don’t want to purchase the wrong set (6) tires and regret it.

again thank you in advance for everyone’s expertise  and experience. I am learning.

A little bit confused and need a bit of guidance, to start my tire size is 275/70R22.5 , the only tire I can find with a max load 6940 with PSI of 125 is Goodyear G670, all other tire brands that has 275/70R22.5 has a max load 6940 with a PSI of either 130 or 131 psi. 

The Accuride rims I have state 125 max psi cold, as pictured, 

is there any unforeseen problem that could arise using any other brand tire that has max load 6940 with a 130+ psi on the rims.

thank you all in advance for your expert knowledge and advice.

Any recommendations on Southwire vs Esco / lyght or any other reliable brands to replace IOTA ITS50R, just found a burnt wire on my IOTA. Been meaning to replace it long ago but life happens and things get put on hold, also I forgot, Until this post and went out to check my transfer switch and noticed a burnt wire. Yes I have dodged a mishap, time to play the lottery.

thank you for any and all insight on new transfer switch recommendations 

I found my paint codes on pedestal under driver’s seat. “Sticker marked DIAMONT. 

Hello I had same problem. Took step assembly apart only to find out there is a plastic or composite ball bearing that wore out not the gears. It seems to be 1/2”, so I ordered a pack of 1/2” Delrin plastic ball bearing G1-100, came in 100 pack for about $14. (Only need 1) slight over kill, it’s been 3 years and no issues, works like new. 
hope this helps out others. 
 

Robert Kurthy 

2006 Monaco Knight 40PDQ

Hello  Berry W.

just do a search of 

cat-am71 connector

you should find one that will work for the amount of wires you have

happy repairing 😃