Jump to content

Trinidaddave

Members
  • Posts

    89
  • Joined

  • Last visited

Posts posted by Trinidaddave

  1. My slides began acting up on my 05 Safari Gazelle when returning from my last trip.  I have quad slides with Power Gear electric drive motors.  My large living room slide is the only one that works  when I push the out button, but it will not come in, all other slides seem dead.  I did connect my rear slide opposite the bed directly to the battery so we could unload the coach from our trip.

    My controller is obsolete but it doesn’t show any signs of damage.  It is an analog device with six mechanical relays that route the circuits to each slide out.  I isolated the ignition lockout relay yesterday with no change in operation.  

    Today I plan to begin tracing each circuit through the coach until I find the component that is common to all the slides. 

    I will follow up on this post if I find the resolution.



     

  2. You first need to determine what is shutting them down.

    1. Are the receiving proper voltage?  You will need a meter for that.

    2. Are the compressors drawing too much current?  Resulting in internal overload opening.  This will require an ammeter.

    3. Are the compressors overheating?  Maybe the units require service and cleaning.

    4. It’s not normal for both units to be wired to line #1.

    5. don’t rule out the thermostat just because it’s set at 60.  It could be a component in the thermostat overheating.

    it’s really hard to guess without doing some checks.

     

  3. I would disconnect the power in the control panel inside the unit. 
     

    Your air conditioning unit may need to be serviced!  If the unit is dirty, motors need oil or airflow is restricted it could be why your unit is drawing the high current and blowing the fuse.

    Again you should have a clamp on ammeter to check the current of the compressor and fan motor.  
    If you are able to open the unit these meters will tell you a lot about your equipment.

    good luck!

  4. The purpose of the fuse is to protect your wires. You will need to find the reason that circuit is drawing over 10 amps.

    Do you have a meter, every owner should carry a meter even if they don’t know how to use it.  In time you will become comfortable using it.

    You can start your troubleshooting by pulling the fuse and searching for the short using the resistance setting (ohm) scale on all the devices you mentioned on that circuit.

    You can disconnect all the items you said were loosing power when fuse blows and replace the fuse, then reconnect them one at a time. This will isolate your trouble to a specific component.

    This may take some time, but it’s the only way to find the short unless you can just physically look at the wires and find something obvious.

×
×
  • Create New...