Moderator's EDIT.
The model in the "signature" may have been incorrect. It is now a DYNASTY as indicated in the PROFILE. The original was a 2006 Diplomat Platinum III. Not aware of a DIPLOMAT Platinum. Therefore if it IS a Dynasty, I am NOT aware of any Dynasty that had the Intellitec EMS system with the board that did the load shedding.... NEED TO VERIFY MODEL as the content has been focused on a system that is NOT in a Dynasty. End of Edit
I have good voltage at the breaker, but no power to the front ac unit or at the junction box below it where the rv wiring is tied to the unit. The romex wire coming out of the breaker box is orange and the wire coming into the junction box under the front ac is yellow. Because these wires are different colors, I assume that there is a junction box somewhere that I cannot locate. I have tried using a wire tracer and depending on where I start (breaker box or junction box) the signal disappears somewhere mid coach in the ceiling. I can’t believe that Monaco would have put a junction box in an inaccessible place like the ceiling, but I guess it’s possible. If I can’t figure out where the break wire break is, I’d like to just run a new wire from the breaker box to the front ac unit. My questions are: does any of this sound familiar and what’s the best fix? Thanks!!!