Wheelin

Dining room and couch. Left rear slide and top corner on rear of slide.

Ok I loosened the spring tension and that helped a little bit. While I had the topper thrown up on the roof, I ran the slider in and out. The one side does not want to seat tight up against the wall on the top corner of one side. It’s seated at the bottom good and tight but the top corner on one side is leaning in a good inch or two. Is there an adjustment for this? I found the adjusters underneath to move the room up and down but that did nothing but put the slider in a bind, so I moved it back to where it was. Any suggestions?

Ok, that’s kinda what I wondered. I’ll try this tomorrow. I’ll let ya know how it works. thank you!

The entire topper. Brackets, fabric and rod. It all came as a set. The dealer was supposed to measure all dimensions before ordering. I hoping there is a way to loosen tension on the topper as I think that is where the problem is but I’m not sure. It makes sense because I still have fabric about two layers of fabric left on the rod.

So….I installed a new slide out topper today from carefree. Now my slide out will not seat all the way out at the top. The bottom seats good. It was not having this problem before I installed the topper. I think the topper is causing this problem. With slide all the way out there is still fabric left on the spool so I know it’s not short. I can turn it by hand but it is very stiff Is there a way to loosen the tension on the topper when it is fully extended?