Cajunboy1959

I found this

Does anybody have any information on Microsoft's purchase of Bluefire and how it affects the use of their engine diagnostic systems?

 Rivertown RV Salvage Yard Kentucky
[Mobile] +1 502-269-1301

Rivertown RV Salvage Yard Kentucky

Hi Everyone,

Thanks for your responses. I should have mentioned that I'm putting in a new 7 pin harness plug. See attached picture.

Gary

MODERATOR EDIT.

This post was used to create a duplicate topic on the same issue.  That is a violation of site rules.  It has been combined, along with the responses, into a single topic.  

END of EDIT

Can anyone help me find the wiring diagram for a 2004 Safari Cheetah 38 PDQ 7 pin wiring harness on back of coach fir toad lights. I have Identified right turn, left turn, brake lights and running light wires. I don't know what pin they belong on. I have separate brake lights and turn signal lights.

I have a Roadmaster Nighthawk tow bar with a 7 pin to 6 pin wire harness.

Thanks for any help.

Gary

Can anyone help me find the wiring diagram for a 2004 Safari Cheetah 38 PDQ 7 pin wiring harness on back of coach fir toad lights. I have Identified right turn, left turn, brake lights and running light wires. I don't know what pin they belong on. I have separate brake lights and turn signal lights.

I'm in the same boat with winterizing in the past 2 days. We will be in the teens here near New Orleans for two consecutive days.

I had the same issue with my 2004 4 slide Cheetah. 

If it is not your ignition being on then check the following:

1. My slide relay control board was in my inverter bay up in the ceiling under a black plastic cover. There is a circuit breaker and a blade fuse. My blade fuse was blown and it fixed the issue.

2. Like someone mentioned all bay doors must be closed if there are switches on the bay doors.  Mine dies not.

3. In the rear bedroom fuse and circuit breaker panel there is another blade fuse there.

I hope this all helps.

Gary

Hi Paul,

Thanks. I have not but I will be calling them today.

Hi Tom,

I have looked for a Power Gear 140-1140 duel motor synchronization controller for several months with no luck. I've contacted over 10 RV junk yards. They should be called " gold mines" My last resort will be to put 2 separate switches one for each motor. M&M Electronics said they have repaired several of these controllers. They offered to diagnose the controller for $95.00. I have to pay for shipping to and from. Before looking at the board they gave me a repair range from $400.00 - $800.00 over the phone.  I shipped to them last week. I'll provide more information as I get it. They said about 2-3 week turn around from start to end.

Thanks Frank!

Hi Frank,

Thanks for all your input and wisdom. It is much appreciated.  Can you repair the power gear duel motor synchronization controller model # 140-1140.  The board has 6 relays, several components such as resistors, capacitors, diods and micro chips. Please see attached picture. Both of the motors work fine with 12 volts supplied directly to them. Wiring harnesses check out good. Any help would be appreciated. 

3 hours ago, willbo777 said:

I have had them do several things for us.  Reprogram the multiplex switches to do various things they didn't do prior, they recorded the software for our coach, they have rebuilt 2 switch panels.  All said I have been very pleased, both with the price and turn around time.

Thanks willbo777

Hi Scotty,

I have a 2004 Safari Cheetah 38pdq.  I need to have a power gear duel motor slide out synchronization controller model# 140-1140. Any input would be appreciated. 

Gary

Has anyone used M & M RV Electronics for fixing obsolete rv Electronics?

I gave been to their website and it seems like they know what there doing. I'm just checking to see if anyone on Monacoers has any knowledge of them.

Thanks 

Thanks Jim. I was hoping there were other options

Gary

The only reason I ask is that I talked to lippert Friday and they want over $8,000.00 for the following: Powergear 140-1140 would be 386185. You will also need 2 new motors which are 368471. A new switch harness which is 368909, and a new teach pendant which will be 386478. 

Can I replace a Power Gear Duel Motor Controller with another power gear controller?

I have a rear passenger slide controller that is not working Model# 140-1140 . I cannot find one of these controllers anywhere. 

Hi Ray,

Something does not look square.  I agree there should be no gap.

On 9/20/2021 at 7:45 PM, Skipjack said:

I just had my trailing arms replaced a couple of months ago. I did not see a problem, but with everything I read I didn’t want to take a chance. I ordered the parts from Source engineering, and had a local truck shop replace them. 
The other reason I went ahead and did it was, I have a friend with a HR in the range of the recall, and actually had his arms break.

 

Hi Skipjack,

Can you give an idea of the price of the new parts from Source engineering? And the labor cost to install. Thanks

Thanks Bill!

Hi Bill,

I'm kinda new to the site. How do I search for the part on this sire? Thanks

Where can I find a PowerGear Slide out Sync controller 140-1140 for my 2004 Safari Cheetah? It operates 2 slide motors for the rear passenger bedroom slide. Thanks in advance.

These are the original hydraulic hoses for the Power Gear leveling system see attached photos. You will see the relief PSI is 3450.

One additional picture showing braided line

It looks like the braided hose just below your 

(SAE100R2AT) hose is just like the ones in my 2004.

2 hours ago, Happycarz said:

I’m sorry. My brain was on hydraulic slideout hoses, not jacks. I looked  at what coach you had and realized my error. My mistake. 
 

No worries