Cajunboy1959
Members-
Posts
41 -
Joined
-
Last visited
Required Information
-
FirstName
Gary
-
Make
Safari
-
Model
Cheetah
-
Year
2004
-
City & State
Slidell
Optional Information
-
Full Address (Optional)
2156 Hampshire Dr, Slidell, Louisiana, 70461
-
Brief Bio (Optional)
Retired. New to RVing. First Class A coach.
Recent Profile Visitors
The recent visitors block is disabled and is not being shown to other users.
Cajunboy1959's Achievements
1
Reputation
-
Replacement washer fluid tank - 2013 Diplomat
Cajunboy1959 replied to KeithP's topic in General Motorhome Discussion
Rivertown RV Salvage Yard Kentucky [Mobile] +1 502-269-1301 -
Replace or repair fancy Monaco rear mud flap.
Cajunboy1959 replied to rschley's topic in General Motorhome Discussion
Rivertown RV Salvage Yard Kentucky -
No wires to 7 pin socket on back of Safari Cheetah
Cajunboy1959 replied to Cajunboy1959's topic in Toads
Hi Everyone, Thanks for your responses. I should have mentioned that I'm putting in a new 7 pin harness plug. See attached picture. Gary -
No wires to 7 pin socket on back of Safari Cheetah
Cajunboy1959 replied to Cajunboy1959's topic in Toads
MODERATOR EDIT. This post was used to create a duplicate topic on the same issue. That is a violation of site rules. It has been combined, along with the responses, into a single topic. END of EDIT Can anyone help me find the wiring diagram for a 2004 Safari Cheetah 38 PDQ 7 pin wiring harness on back of coach fir toad lights. I have Identified right turn, left turn, brake lights and running light wires. I don't know what pin they belong on. I have separate brake lights and turn signal lights. I have a Roadmaster Nighthawk tow bar with a 7 pin to 6 pin wire harness. Thanks for any help. Gary -
Can anyone help me find the wiring diagram for a 2004 Safari Cheetah 38 PDQ 7 pin wiring harness on back of coach fir toad lights. I have Identified right turn, left turn, brake lights and running light wires. I don't know what pin they belong on. I have separate brake lights and turn signal lights.
-
Slides not working; 2005 Cheetah
Cajunboy1959 replied to 1nolaguy's topic in Body, Awning, Roof, Slides, & Steps
I'm in the same boat with winterizing in the past 2 days. We will be in the teens here near New Orleans for two consecutive days. I had the same issue with my 2004 4 slide Cheetah. If it is not your ignition being on then check the following: 1. My slide relay control board was in my inverter bay up in the ceiling under a black plastic cover. There is a circuit breaker and a blade fuse. My blade fuse was blown and it fixed the issue. 2. Like someone mentioned all bay doors must be closed if there are switches on the bay doors. Mine dies not. 3. In the rear bedroom fuse and circuit breaker panel there is another blade fuse there. I hope this all helps. Gary -
M & M RV Electronics Ohio City, OH
Cajunboy1959 replied to Cajunboy1959's topic in RV Service Reviews
Hi Paul, Thanks. I have not but I will be calling them today. -
M & M RV Electronics Ohio City, OH
Cajunboy1959 replied to Cajunboy1959's topic in RV Service Reviews
Hi Tom, I have looked for a Power Gear 140-1140 duel motor synchronization controller for several months with no luck. I've contacted over 10 RV junk yards. They should be called " gold mines" My last resort will be to put 2 separate switches one for each motor. M&M Electronics said they have repaired several of these controllers. They offered to diagnose the controller for $95.00. I have to pay for shipping to and from. Before looking at the board they gave me a repair range from $400.00 - $800.00 over the phone. I shipped to them last week. I'll provide more information as I get it. They said about 2-3 week turn around from start to end. -
M & M RV Electronics Ohio City, OH
Cajunboy1959 replied to Cajunboy1959's topic in RV Service Reviews
Thanks Frank! -
M & M RV Electronics Ohio City, OH
Cajunboy1959 replied to Cajunboy1959's topic in RV Service Reviews
Hi Frank, Thanks for all your input and wisdom. It is much appreciated. Can you repair the power gear duel motor synchronization controller model # 140-1140. The board has 6 relays, several components such as resistors, capacitors, diods and micro chips. Please see attached picture. Both of the motors work fine with 12 volts supplied directly to them. Wiring harnesses check out good. Any help would be appreciated. -
M & M RV Electronics Ohio City, OH
Cajunboy1959 replied to Cajunboy1959's topic in RV Service Reviews
Thanks willbo777 -
M & M RV Electronics Ohio City, OH
Cajunboy1959 replied to Cajunboy1959's topic in RV Service Reviews
Hi Scotty, I have a 2004 Safari Cheetah 38pdq. I need to have a power gear duel motor slide out synchronization controller model# 140-1140. Any input would be appreciated. Gary -
Has anyone used M & M RV Electronics for fixing obsolete rv Electronics? I gave been to their website and it seems like they know what there doing. I'm just checking to see if anyone on Monacoers has any knowledge of them. Thanks