Jump to content

RVKnight

Members
  • Posts

    18
  • Joined

  • Last visited

Required Information

  • FirstName
    Garland
  • Make
    Monaco
  • Model
    Knight
  • Year
    2006
  • City & State
    Lake Elsinore

Optional Information

  • Full Address (Optional)
    21 Corte Lateuza, Lake Elsinore , California, 92532

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

RVKnight's Achievements

6

Reputation

  1. I appreciate everyone’s input and value the suggestions. We decided not to use the slide for the remainder of the trip. Would hate to get in a situation where once extended it would not retract. Once I get back to home location I will have the shop take a look. Once I find the issue I will post the problem and fix.
  2. Thanks, Tom. I will try to contact https://www.monacoers.org/profile/704-throgmartin/ and see if he has any suggestions. Any photos I could provide would need to be taken with the slide extended and as mentioned I’m too concerned about it not retracting I’m to nervous extend. Thanks, Carey. I have a can of seal lube with me and will give it a try.
  3. My 2006 Monaco Knight PDQ with pana-slide is coming in a such a steep angle when retracting it comes very close to hitting ceiling. If I back slide out a little then start over it drops down and then I can full retract the side and it fits just fine. This just started happening on this trip. I’m not sure what causes this and fear it will not retract if I keep using the slide. Decided not to use slide remainder of the trip which of course takes away lots of room. Does anyone have any suggestions to what may be causing this issue.
  4. Just recently replaced the air pressure valve sensor on my 2006 Monaco Knight after having an issue with lowering leveling jacks. Prior to replacing valve was getting an “engage parking break” warning preventing the jacks from engaging. The replacement resolved the issue. However, more related to your question, I did notice during the repair by moving the plunger handle which engages the break caused an air leak around where the plunger is sealed entering the valve housing. You may want to check for leaking in that spot. I was fortunate in getting help from this forum to resolve my issue. Wish the same for you. Best of luck.
  5. Thanks, Larry. Veurink is my go to but unfortunately they did not have the lamp.
  6. One of the fog lights on my 2006 Monaco Knight PDQ is burned out. I have not been able to locate a replacement without having to make modifications. Can anyone direct me to a place where I maybe able to locate a replacement for the original lamp unit.
  7. By going through the training I would have denied many a body shop work.
  8. Jim, that is a good approach.
  9. We opened a separate account at a different bank. That way if it gets breached they will only get what is in the fuel card account.
  10. I too use the TDS fuel card and wonder why everyone who has a diesel does not use the service.
  11. POPS sold my boat and the rep in so cal did an excellent job every step on the transaction.
  12. Thank this appears to be the same issue. The diagram will be very helpful. Much appreciated, Garland G
  13. Thanks Rich, your response is helpful. My camera system has had intermittent problems for years too. On the advice of Doug I contacted RVCAMS and we are trying to work out a replacement or upgrade.
×
×
  • Create New...