Jump to content

Gonzalo

Members
  • Posts

    57
  • Joined

  • Last visited

Posts posted by Gonzalo

  1. On 2/17/2023 at 12:42 PM, jacwjames said:

    Have you checked the belt molding that goes around the top of the motorhome.  This is the seam between the roof and side panel.  The belt molding has a bead of caulk on that seals to the side of the coach, but it takes a small section of bad caulk to cause a problem.

    I had to repair a similar type leak on passenger side rear.  I ultaimately found a section of bad belt molding it was where the rear cap mated to the roof, there was a small hump that was not sealed properly.  I redid all mine in 2021, I bought a set of long plastic scrappers from harbor frieght and scrapped al the old caulk out and then used Geocel to caulk.

    thanks a lot i am thinking to rent a or buy a scaffold because  the belt molding is about 11 foot from floor and remove old caulk and reseled with geocel 

    9 hours ago, Larry Laursen said:

    The 05 Endeavor doesn't have a A/C condensation drainpipe.  The water coming off the A/C runs across the roof.

    Leaks coming down the inside of the walls most likely are coming from the belt line.  The old sealant needs to be removed the entire length of the coach and replaced.  I have an 05 Endeavor have experienced the problem.

    thanks larry i will check the A/c drain pipes but the RV is park and happens only when it rains but good advice 

  2. MODERATOR EDIT

    This appears to be a new topic covering the same issue.  That is not permitted.  It has been merged into the original.  Please do not post new topics for problems already posted, especially in the last few weeks.

    Your Profile is incorrect and was edited.  Please review it.  A Phone number is required now and there is a generic one that was used.

    Your attention to the above is appreciated 

    END OF EDIT.
     

    I just bougt a 2005 Holliday Rambler Endover and I discover a water leak by door entrance  i did remove part of the inside liner ,and see the leak but i cant find out were come from I did went to roof and seals some litle cracks and add silicone clear on top of the door awning  last nighy rain again and i see some wet spoy againg did any body has a leak like this or know how detected  my last guess is the big awning at passanger side Help please . attach some pictures 

    IMG_0808.JPG

    IMG_0807.JPG

    IMG_0993[1].JPG

    IMG_0994[1].JPG

    IMG_0996[1].JPG

    IMG_0998[1].JPG

    IMG_0999[1].JPG

    IMG_1001[1].JPG

    IMG_0995[1].JPG

  3. I have a 2005 holiday rambler with water leak at the right side od the front manual care free awning  how i can remove the inside cabits or how detedt the leak i did cauking al the seals om top the door looka like the awning screww may be allow the leak also how i can remove th manual care free awning  the wood on top the door is bad nneds to replease but i can find the leak i look and repach the roof around antenas but syill leaks the roof looks good is two peaces 

  4. I just Bought a 2005 Holiday Rambler it has 4 Slides, Original Carpet but the carpet is showing tear and wear Wich is my best options to change this floor in the whole RV. I did look different options and I am confused. Vinyl Planks. Hard wood, tile, Linoleum, or come back to carpet.  Need help. 

    We went to a floor distribution, and they said a 2mm glue no locking mechanism because the temperatures in the RV could be extreme in winter or hot summer. some of them can be up to 6mm. prices varies. I saw some you tube videos and is a lot of labor removing the carpet staples by thousands. the slides are even more difficult. open to Ideas.

    IMG_0767.JPG

    IMG_0770.JPG

    IMG_0772.JPG

    IMG_0801.JPG

    IMG_0803.JPG

    IMG_0780.JPG

    IMG_0797.JPG

  5. On 10/5/2022 at 9:17 PM, David White said:

    Gonzalo, I have the same MH and as pointed out, the little magnetic switch is under the step. There is a wired half and another half that matches up when the step is closed. Put the step out to see if part has come off,  but be careful because it can close and cause injury. When closed, the parts should be close together so the magnetic activates the switch and turn off the light.
    If the parts are in near contact and the light still stays on, it might be a faulty switch.  Mine still gives be a light intermittently!

     

×
×
  • Create New...