JTerry

Thank you Rik and Tim for your help. I really appreciate your input.

The oxidation on my fiberglass roof causes a mess every time it rains. I am considering paint the roof with Henry's 887 Tropical. My roof has Dicor self leveling sealant and I am concerned about the paint adhering to the decor and also adding Dicor on the paint to repair future cracks. Has anyone had any experience with this?

Thank you Jim J for your experience. It really does appear to be as you described with the door jamb putting pressure on the tile.

Thank you to Steve P, Bill B, Jim J and Bob K for your responses to my tile problem. The tile is located in the doorway to my half bath. A corner of the tile is actually under the door frame. That corner has dropped about 1/4" while the corner on the opposite side has raised almost 1/4" and the tile has cracked. My floor is not a heated floor so I don't have that to contend with. I'm debating as to whether I should go ahead and bite the bullet and take up that tile or if I should wait until the spring. I have posted some pictures that help to see what's going on.IMG_1357.HEICIMG_1356.HEICIMG_1355.HEICIMG_1354.HEIC Suggetstions:

Our 2009 Dynasty has ceramic tile and one of the tiles is lifting up and has cracked. Has anyone experienced this and have any ideas what would cause this. I have 3 extra tiles and plan to replace this one. I am concerned there might be an issue that needs to be addressed.

Thank you Martin and Ric. I hadn't thought about the hydraulic fluid. We did lose a little when disconnecting the lines.

We removed and resealed all three stabilizers. After installing them back on the coach the Hydraulic, Ride, and Tag lights are all flashing. Additionally there is an intermittent beep. I have checked the manual and can't find any information that would cause this. Anyone have any ideas.

Ray Davis: thank you for your help. This will be music to my step son's ears.

I am trying to help my step son get information on his Aqua Hot system. When he purchased his Fleetwood he discovered there was a leak in the copper tubing. He can repair the leak but has not been able to find the black material covering the copper coils. Does anyone have any idea what this material is and where it can be purchased? Thanks for any info

Frank, thank you so much for your help. It will be Thursday before I have a chance to check out your suggestions. I will let you know how it goes.

Bobby Linn, Thanks for the info regarding Bay Lights. My coach does not have a Bay Light switch in the wet bay. The only switch I have found is on the left of the entry door. I'm going to keep searching but I think the final solution is to wire a new set of lights. Ben, My bay lights do not have switches. There is a florescent light in the wet bay that is apparently on a different circuit, it works.

Update on passenger rear slide seals. It appears my seal is a one piece seal. Has anyone installed seals on a 2009 Monaco Dynasty? Please share any information you can.

My passenger side rear slide needs new seals. I have done some research and am considering the universal seal kit from Uni-Seal. Has anyone had experience installing their universal seal? Did you encounter any problems installing it? Are there other recommendations?

Bob K. Thanks for your info regarding the bay lights. The only step light switches that are not working are the Bay Light and the Porch Light. The others appear to work. I will check the VCF-8 fuse in the FRB. Bobby Linn, Thanks for the info regarding Bay Lights. My coach does not have a Bay Light switch in the wet bay. The only switch I have found is on the left of the entry door. I'm going to keep searching but I think the final solution is to wire a new set of lights.

Frank, I checked and the Green LED labeled VCF SW HSE in the FRB is on. As for switches, there are switches just to the left as you enter the door. These are: Porch (not working) Handle/step lights-works, Bay lights switch lights but bay lights don't work, Battery cut off- switch lights but I'm not sure what it does, Ceiling lights-works, External TV-haven't tried yet.

I am still trying to track down the problem with the bay lights not working. I downloaded and printed the wiring diagram and it shows there is a 10 amp fuse in the rear run bay for the bay lights. I looked there and could not find a fuse for the bay lights. Anyone have any idea if there is actually a fuse in the circuit.

Update on windshield wipers not working: A big thank you to Frank McElroy for the information and instructions to bypass the 5V power supply for the smart wheel. I finally wired in a 12V--5V converter and now I have wipers and cruise control. One more fix done.

Thank you Tom for all the good information. I am basically sure the motor is bad but jus t want to check it out before spending $343 for a new motor. Once I get it working I think I will address the wiper issue. Thanks again

Moderator's EDIT. This new topic was merged with the original one posted on Sunday. End of Edit. I removed the windshield wiper motor today but before ordering a new one I want to check the motor. Does anyone know where I can find the color codes of the wiring harness for the motor and the normal amp draw?

Tom: I am replying to this post because you had closed the other post to replies until we figured out what system I have. In that post someone was going to reach out to me via phone. That didn't happen. I have been out of town for a few days and got back today and verified that I do have the Konsberg CCM. I was unaware that you were not supposed to hook up a battery charger to start the engine if the chassis batteries are down. I have had to do that a couple of times. Hopefully I haven't damaged the system. My chassis batteries are not being charged when on shore power or on generator. I plan to clean the Big Boy tomorrow morning and see if that solves the issue. I apologize if I have been a pain for everyone but this coach has been a bit overwhelming. I also would like to know where we go to get help if there is a problem with this Konsberg system. Thanks for all your help.

Bob, thank you for the photo. I see you also have a 2009 Dynasty Yorkshire. Does your's have the Kongsburg system? If so since the system is discontinued how do we get repairs going forward? I am thankful I discovered this forum. Many of my questions have been answered already.

Thanks Bob for your help. We just purchased this coach about 1 1/2 months ago and all I have done since getting it is discovering problems. This salesman solenoid, is it in the closet in the rear where the fuse panel is located?

Thank you

Thank you

Thank you Tom. I have the Intellitec board.