Jerry G

Was @$ 100 for a generic replacement at HD or Lowes, I forget. Easy to do.

I switched to waxing the windsheild and all windows. Easy on, easy off, water beads and runs right off.

Try Braddandhall.com 800 445 1830 I just got the bearing ring for my chairs there.

I put in the same units, 15k each. I put a cardboard baffle in the ducts so one does the bedroom and the other the living room and that pretty much eliminated that issue for us. We can go to bed with ac on in bedroom, and have the livingroom programmed to come on heat at 3am, so it's warm when we get up.

First thank you to the many who have provided info and knowledge over the years. I guess I finally understand the strong recommendations to go res. The JC unit has been great for 5 yrs. But I have had nothing but problems for the past 3 months with misc parts remaining on the norcold. Changed board, brow, fans and thermostat and the unit randomly would power off, after as many as 10 days. Had 4 days to find one, get it delivered and installed b4 heading up to the mountains. So, I had it yanked. Window came out and back in, easy. Doors off both units, slid in and out with ease. For those interested went with Whirlpool 2 door 14.3cuft , took off handles, model WRT314TFDB $749 on sale for $599 at Lowes. Smaller than space, requiring no mods. Had to buy icemaker as an add on, @$100. Be sure u have room for door swing. Again, thanks.

Thanks for all the input. For those interested. I have the 120v from JC. Keeps freezer at 0 and frig at 33 set on 4 and 75 degrees outside. Rarely have had to turn it up beyond 6 in warmer temps. I do have it under our awning.

Moderator Comment. There were duplicate posts time stamped within a minute. This is against the Forum’s rules. The two have been combined. Please to not duplicate post or if an accident, notify a moderator. End of Moderator comment. I dont heed to hear about switching to a res refer. Have amish cooling unit. Works great, 6 yrs. Control board went bad, temp stuck at 41°. Had control board, brow, temp sensor and fans replaced. Randomly, 10, 7, 1 day power will turn off. Happens on electric and propane. Brow will occasionally will give a AC/RE code. 20% of instances. Been looked at by a Tech, everything checks ok. Norcold refuses to replace the control board under warranty, claiming my inverter is randomly sending bad power. Does anyone know of another source for a replacement board, or a solution to my issue.

Just happened to us. Found a 5 amp fuse on the control board blown. Appears a fan has bound up and is blowing it. Took the cover off the control board outside, our fuse is on lower right side. If it blows again, find the wire going up to power the fans and disconnect it, replaced fuse again and it's running while we wait for delivery.

I had similar in my 01 Dynasty. Cummins and one other place said they could find nothing and brakes were OK Decided to put black electrical tape over idiot light. Stayed on for a couple years. Got cut off and had to hit brakes hard(I use exhaust brake to slow mostly). What do you know. Light went out and hasn't come on in another couple years for whatever it's worth.

I believe my tech connected the blue wires bypassing the heat pump, removed the existing thermostat and connected those wires to a simple wall mounted thermostat in the same location. It works fine when we needed it. Surprised, the Houghton has worked great down to 28-30 degrees. We've rarely used the furnace since installing. But will when colder than that.

2001 Dynasty. yellowstone early Nov. Skirt around rig. No problem til Temps hit 15 below.

After spending @ $200 twice in 7 years, asked tech what options I had when the 3rd call was going to cost another $200. Decided to spend another $200, but had him install foot pedal flush and 8 years later haven't had to have it repaired again

Can't help with air bags, but what highway did that?

We live in Grand Teton NP. DAMAGE is extensive in YNP. All 5 entrances are closed They've been evacuating the park for two days. Northern loop will not reopen this year. Southern loop will not open for another 5 days at the earliest. Reservations to enter the park are being considered. Per Superintendent.

I am not mechanically inclined, so I can't explain. Here are the instructions and my guess is it has to do with the plenum and the mounting of the separation baffle. Beyond that you might try Recpro, but I don't think the have tech support.