Karl Hampton

I recently had my drivers side (the arm rest area) - instrument panel rebuilt (not the dash panel). While that came out well, one casualty was my “idle up/idle down” switch (see below). Note that part of the switch probably 2 prongs, are broken off (total should be 6 prongs?). It is 1” long by 3/4” wide. Inscribed as follows as best I can read it: 9803 L203 COLD CONTACTS Q.1A 125VAC-DC 1AMP 28V MAX ************** MICRO SWITCH FREEPORT ILLINOIS AML 20 SERIES **************** So far I haven’t found anything, including at Northwest supply to replace it (size wise). I didn’t use the switch that much, so one solution would be to abandon it. However, it occurred to me that someone on the forum might have one to sell or know where to look for one, so any input is appreciated. Thanks Karl H - 1998 Signature

It looks great! What kind of coating and where did u have it done? karl H

Over the years I have been advised to never assume anything about what Monaco did or didn’t do - and that is good advice. That said, my 1998 Signature 450 hp M-11 according to my manual - is 9 gallons for the pan and “10 gallons including filter.” You could also contact Cummins if you don’t have an owner’s manual. karl h 1998 Signature

My 20 year old “Idle Up/Down” switch and my Cruise Control “Set/Resume” switches fell apart when redoing my side panel (see photo if it comes through). Does anybody know where a place to try to replace them might be? 1998 Monaco Signature. Thanks for any help, Karl

The TDS Logistics fuel card sounds good, but I am apprehensive about providing them my social security number. Is everyone providing the SS number or is there away around that?