Barry W

Hope this in correct forum, need location of Electrical fuel pump

2006 Monaco Diplomat PDQ

Barry

Maybe this would work:  Wireless TV Receiver - Wireless Joey | DISH

Put bike rack on Gran Cherokee

https://www.rvrepairshoplubbock.com/

Only know what I have read in reviews, but sound good.  Do know would not take anything to Camping World.

If you have Dish, you might check into the Wireless Joey.

https://www.dish.com/equipment/joey-receivers/wireless-joey/

Exactly what I decided after going back and reading this same page.

Thanks

Finally bit the bullit and bought four Crown AGM batteries for house.  In process of setting battery type on Magnum, discovered AGM and AGM 2.  Just wondering what the difference?

Discovered the difference, but do not know which category the Crown batteries fall in.

Note 2: specifications for Concord (Lifeline Series) AGM batteries.
Note 3: specifications for East Penn, Deka, Discover and Trojan AGM batteries.

Any one know what Sam's Stores stock the Duracell AGM batteries, or if another source close to Sam's price?

What model Pioneer?

Read pages 7-9 and try the suggestions for hard reset and Calibrate El.  Have used the calibrate El several times and Travler started working correctly.

TRAVLER Antennas Module.pdf

1 hour ago, ColoJim said:

When I try to extend my door awning it starts and stops about 3 seconds later. I think it is hanging up or it thinks that it is fully extended. I tried shaking the arms when it starts to extend and they seem free. When it stops ( about 3” to 4” out) I cannot turn the reel. It seems like the motor is holding up the reel. Any ideas?

Read this: https://www.irv2.com/forums/f115/entry-door-awning-parts-218274.html

3 minutes ago, Ray Davis said:

 

Yeah great news .   Air cond is nice but heat is essential especially when DW is cold .   It sure feel nice when we find a fix , it even feels nice  when we can help .   That dip sw was probably like when it left Monaco and no one bothered to figure it out .   This forum is the best , great members here .                       Almost no bickering 

Almost

Thanks

1 hour ago, Ray Davis said:

 Barry , Your model is a little different , my board is on top under cover # 38 .

 Anyway you do have a control somewhere . I saw in your manual it looks like you have a control box accessed from inside .      https://www.manualslib.com/manual/799601/Dometic-57908-321.html?page=15#manual

  Good luck

Was able to find dip switches from this post, filp furnace on reset thermostat now both furnaces appear in thermo and both work.

Do not know why switch was not right but it is now.  Thanks to everyone that posted help

On 10/6/2020 at 2:29 PM, Ray Davis said:

So , zone 1 is the front and A/C that's where I would check the dip switches 

On the roof remove the A/C cover then on the pass side is the control board , it is accessed by removing a metal cover .

The dip switches are on that board . They are small and delicate so go easy with them . On mine I have a furnace sw 3rd from the bottom .

If your furnace dip sw is off turn it on and do a reset of the thermostat so it will recognize the new setting hopefully that will cure the problem .

Take a picture of the original settings so you can return to those settings if necessary .

BTW there is 120 v up there so be careful .

Climbed on roof removed cover on front AC and what I thought was the opening on pass side to control board.

Found capacitors but no control board with dip switches.  All that was in the opening was part nos. 36,43,& 44

This is the model of Duo-Therm 630035.331

4 hours ago, Bob Nodine said:

Is the new unit installed in the rear one that requires the new thermostat or did the installer exchange the circuit board for an older circuit board compatible with the old thermostat? 

Exchanged circuit board, the zone 2 where the new unit is installed shows the furnace under the fridge. Zone 1 where old unit is does not show furnace that is under the kitchen cabinet.  Have not check the dip switchs on old unit yet will get to that tomorrow.

1 hour ago, Ray Davis said:

 Barry ,  is this a recent condition or has it shown up on the thermostat before ?

 Do you still have the original A/Cs ?  If they have been up dated you may need to change a dip switch setting .                                                                             Good luck

This is first time I have checked this furnace to try to use since owning coach for three years.  First trip in cold weather.

The rear AC was replaced fifteen months ago, front AC is original as far as I know.

Where would I find info on t he dip switch settings?

Will do more research

I googled the reset procedure yesterday and reset the thermostat twice, still have the same problem.

Am thinking will go on roof and check if wireing is still intact.

When on zone 2 (bedroom) when switching between modes, cool, HP, furnace and fan appear.

On zone 1 (living room) just cool, HP, and fan appear furnace does not appear in display.

Hope this explains without pics, but if neccessary will include pics in the future posts

Thanks for the info, sorry if sounded ungrateful just a OEM kinda of guy, if possible

What is the two blue wires attached to at the ac?

I would prefer to determine why it is not being displayed on current thermostat.

I think I have seen how to reset the thermostat, but have forgotten how and where to find instructions.

Have two furnaces, the one under the frig works good and is controlled by zone two or bedroom side of thermostat.  

The other furnace under kitchen cabinet does not appear on zone one of thermostat, so unable to turn on.

Any help?

Barry

Maybe this is what you are looking for: http://www.rv-project.com/projects/ems.php

Thanks

Stephen A

I am 6'4" am wondering how this double recliner would fit me??