ktloah

All of Mike's posts on his Dynasty have been spot on...TY

You can purchase the gasket with the cups on amazon

20 hours ago, Duffer51 said:

I had the exact same issue with my 04 Dynasty shower door.  On the inside of the shower there is a trim piece with a small screw at the top and the bottom, remove those and the trim piece should come off and reveal pivot piano hinge that can be replaced with one from Amazon for 10.00.

Hardware Essentials 851063 Continuous Pin 24" x 1-1/4" Nickel - Door Hinges - Amazon.com

Hi Ron, this door seems to have a pivot point on the top and bottom of the door. I believe they call it a pivot block. Did you replace yours with the piano hinge?

Thank you all for your information. I called SEA and after looking at my pics, they determined the shower door was not a SEA but KOHLER STERLING. So I called them in Wisconsin and got the usual ( no model# no parts...)we are traveling so when we stop, I will attempt to try to get the #'s from the door like Tom said. If need to, maybe replace everything with a standard piano hinge...

good morning, our 04 Dynasty's shower door will not close anymore. Seems there is a grey plastic strip that runs the length of the door and 1/2 of it is broken preventing the door from closing. It seems this strip acts as a hinge. Not sure how to remove. Thank you all

My 04 Dynasty has the drain for the middle a/c just forward of the right rear drive tire...

Got mine replaced thru M4 Products....great people

Aero muffler or straight pipe it. The cost of a muffler will.open your eyes!

Try the compartment under the drivers seat...left front box in front of the tire..

Yup, 04 Dynasty Robert...

Ok thanks...my Cruise works intermittently...hoping replacing these will solve my problem....thanks again

Hey Steve, not sure they are bad, but the cruise cancel solenoid is suspect

Yup, 04 Dynasty Robert...

Ok, I will check for the #'s. Any idea what the bottom part of this is?  Thank you

Looking for information on just where I can purchase these solenoids. I believe they have something to do with the cruise control. They are mounted on the firewall on the drivers side in the generator compartment. Thanks...

Excellent tutorial Mike.  I am going to start this process in the spring and follow you on u-tube and enjoy your videos...thank you!

Source Engineering in Oregon...he makes his own sensors!

Hey Carl, I changed my sending unit on my 04 Dynasty and was relatively easy to change. 6 nuts to remove along with the wires and removed the unit, installed the new one, hooked up the wires and worked liked a charm. Good luck 👍 

I purchased a top brand cover, their best, covered my Dynasty and in the spring on each corner were telltale rub marks on each corner. NOT a happy camper!! It was parked in my driveway and periodically checked to see if things were tight...I now store indoors

I replaced my rear backup lights with LED. They are pricey but they work great. I just Googled 4x6 led lights and found what I liked...mine work in reverse as well as with the docking light switch..

Your rear lights shown, should be on the docking light switch...pull a light out and check to see if your getting voltage. I replaced mine with LED

Use your DOCKING lights at night

Thank you all, you guys are doing an excellent job

I wash it myself whenever it gets dirty and use F-11 to give it a shine

So I think I found the reason the front A/C is not responding to the thermostat.  After reading exactly how the 10 button thermostat operates, I found that the " program" button mistakenly was pressed and would not allow me to choose a mode. After clearing both programs, it seems to respond fine. Thanks to all who helped me thru this...

Where was the brake switch located?

Thanks Tom, I'll give it a try when we return home.. will let u know, thank you!