Dynasty

Friends. I live in Norway, own a Monaco Dynasty 40' 2005 S chassis. I am in need of trailing arm bushings and tag axle repair kit between brake bilg and slack adjusters ( fork, bushing and pin). Can anybody help with part numbers and suppliers? Thor-Steinar Christensen. Bergen, Norway Monaco Dynasty Bishop III 2005 Cummins ISL 400

Maybe a stupid question, but what. Is this unit doing Thanks friends. I googled and are now a bit wicer🤩

I need help. Can anybody tell me what this blue cap beside the hydraulic tank is? 2006 Dynasty Cummins 400 hk

The trans oil cooler is a separate unit. Low temp water coming from the radiator passing through this cooler on its way to the engine. The Trans oil is cooled in this unit and returner to the Trans. The leak is caused by corrosion from the colors outside due to all the salty winter roads. No water in the Trans oil.engine cooling water is leaking out of the corrosion area. Thank everybody for engagement. I go for Jims proposal. Already ordered from Amazon. Again, thanks a lot.

The trans oil cooler is a separate unit. Low temp water coming from the radiator passing through this cooler on its way to the engine. The Trans oil is cooled in this unit and returner to the Trans. The leak is caused by corrosion from the colors outside due to all the salty winter roads. No water in the Trans oil.engine cooling water is leaking out of the corrosion area. The unit are made of cast iron, and are separate from the radiator unit.

Friends. Just prepareing for å 3 week late summer trip, and during checking everything, I discovered e cooling water leak in the Trans oil cooler. I live in Norway. Have a 2006 Dynasty 38 with Cummins 400 hp. Any good advice where to get a new cooler and what price I will have to pay. All advice are welcome. Regards Thor

Dough. I faced the same problem a month ago. Lock in gear. Only one digit (the gear on lock) show in display. Speedometer also stop working. When turned engine off for a while, everything OK for a few km. I checked connectors, checked the resistansen on the output of the RPM sensor on the back of gear. Everything look good. Ended up changing the RPM sensor and everything OK. Only thing that was badly hurt was the wallet. Insane item price😡

I have the same coach. Faced the same trouble. The door magnet is supplied with 10 cm wire. Then Monaco Connect them to coach wireing with scrimp connectors. Wireing are covered by split loom.. lot of dirt and water from the steering wheel accumulate in this room until the scrimp connector corode and connection go bad. Monaco have used such connection a lot of places where common sense tel waterproof connectors to be used.