Bill C

I have Dash Heat in ALL settings, including A/C and Max A/C.

Hi Ivan, yes I have actually replaced the valve, externally plugging a new one in, and same issue.

Hi Bob, thanks for the info. I am considering "easter egging" the parts on this control board. In which order would you try replacing the components? I'm attaching a pic of the board for reference. Any help would be most appreciated. Thanks, Bill

Good Day pwhittle, I have two numbers on the chip, does a replacement IC chip have to match both numbers? What do the numbers mean? Here are the 2 numbers on one IC chip: MC33030P and CPJQ9934 Thanks, Bill

Anyone know where I can get the Servo control board for the dash heat and air conditioning in a 2001 Monaco Dynasty? Apparently it turns the engine hot water valve off to the unit when the air conditioner is running. When it fails, you get hot and cold at the same time and that’s not a good combination if you want cold air. I posted about this before but I wanted to see if somebody knows somebody that rebuilds circuit boards. Where can I find a used one? Attached are some pics of it. Thanks, Bill

Yes I did Bob, but thanks for the feedback

My Norco 1200 “appeared to” worked perfectly on gas and electric. However, it would not cool. The coils would get hot. The fans would come on and everything look like it was operating normally but inside the freezer nor refrigerator was not cooled. I read a lot of forums and I’ve had a technician on here and he can’t figure it out either. We replaced the control module And we replaced the digital control pad on the front of the refrigerator. None of these helped. I finally replaced the frig with a brand new Norcold 1210. It seems to work fine as well, in gas and electric. However, The freezer only gets to 22° in the refrigerator only gets to about 71. This is a brand new refrigerator just installed by a technician and this is what I get. I called Norco and they say too bad, So sad, we can’t help you because helping you is a safety and liability issue for Norcold. Take it to a repair shop. I’m living in it full-time on a small lot and it’s not easy to move it. BAD Nevercold

Hello Joe. When I installed my passenger side 360 camera, I went through the awning cover at the top and brought it down the side. When I went through The awning I put a grommet there so that the awning wouldn’t rip and went through the grommet with the wire. Unfortunately, I don’t have a picture at the top but here’s one showing where I am mounted my camera at the bottom. Hope this helps

I decided to go with the NORCOLD 1210 Untraline, the direct replacement for my old 1200 model. The reasons: Because of the way my coach was customized when build, and has the aqua hot water lines running under the frig, I have zero room for any size refrigerator larger than mine. I looked in to frigs that were the same size, or will fit in my space ( I did not want to go any smaller), I found these: A. NORCOLD Polar Elite N15DC: Same exact size It has a little more storage than mine (15cf vice 12cf) Was the same size, and ran on 12v Price was $4600 and only came in stainless steel color (the 2 negatives for my wife) B. NORCOLD 1210 Ultraline: Same exact size, same amount of storage. It is only $4000 The door panels from our old frig can be installed on this new one, keeping the same color scheme. These two are positives for my wife. Personally, I still like the very efficient propone option. Hope this helps Bill

Been doing some research, found a new Norcold for $4k, cheaper than any other place I have found, Here is the link: https://www.dyersonline.com/norcold-ultraline-12-cu-ft-side-by-side-refrigerator.html?utm_source=googlebase&utm_medium=shoppingengine&gad_source=1&gclid=Cj0KCQjwhtWvBhD9ARIsAOP0Goiia65Zro7ZhXQZXz9quR0iN0jjcOFtOzpitwzSrWDN2EB0spUNlBIaAnlDEALw_wcB

Hi Vince, thanks for the try, but they are very tight 😞 On another note, I know it's a shot in the dark, but I used to know a Vince Bousa, that is not you is it? Thanks, Bill

Hi Rocketman3, which model Fisher and Paykel did you get, the Model:RF135BLPX6-N?

UPDATE (probably my last): Frig seems to run fine, been running on propane for 26 hours now, fins hot at the top, fan runs periodically to cool the fins, yet after 26 hours, freezer is 47 deg F and frig is 62 deg F. Frig tech said everything seems to be good, he could not see why it was not cooling properly. With everything seeming to be running normal, WHY ISN'T IT COOLING? Seals are good, and besides the freezer and frig seals are diff, yet both have low temps. I give up, unless one of my support gurus can assist, I guess I'll be buying a new frig. Thanks to everyone for their advice, and words of wisdom. No comment is to small, or insignificant 🙂 Regards, Bill

Good info Bob, thanks

Here is my info: Norcold, Serial #: 885123FA, Model: 1200LR (manufactured Oct 2000), Group Code: 01004 I did not see any yellowish substance. I took Bob's advice and tried the rubber mallet technique. Upon completion of the rapping, I turned the frig back on. In A/C mode, for some reason, there did not seem to be heat on the tubes, but perhaps I did not know where to feel. I changed over to gas and, after an hour, the lowest tube, and to some extent, the large round reservoir got warm, especially the lowest tube, but none of the other tubes above that, the ones that cross back and forth, did not have any warmth. Thanks Holly cow, I did not realize lithium batteries had come down so much in price! Thanks

I took Bob's advice and tried the rubber mallet technique. Upon completion of the rapping, I turned the frig back on. In A/C mode, for some reason, there did not seem to be heat on the tubes, but perhaps I did not know where to feel. I changed over to gas and, after an hour, the lowest tube, and to some extent, the large round reservoir got warm, especially the lowest tube, but none of the other tubes above that, the ones that cross back and forth, did not have any warmth.

Hi Michael, please send me anything that you have that will help, I might go this route. Thanks, Bill

My Norcold 1200 refrigerator stopped Cooling. It is the original refrigerator, and was repaired once about 10 years ago by the original/previous owner. I am not sure exactly what was done, but was told it cost about $1500 at the time. Mine was, and always has, worked well since I've owned it, about 8 years now. 2 days ago, the left door fell off due to a lower bracket failure. The frig was left open/off for about 2 or so hours. Ever since then it really does no cooling. All the door seals seem to be tight, as designed. I had a spare control ASSY/power board, and replaced the existing one, no joy - still does not cool. I also had a spare front control panel, and replaced the existing one, still no cooling. The frig seems to run fine, but just doesn't cool. I tried running it on gas and electric - no cooling. I checked the thermistor; it seems to check out fine. I even took the thermistor off the cooling fin, so it would register the temp inside even warmer. Still no cooling. I ran the diagnostic and no error codes showed up. I don't know what else it could be, short of loss of alcohol in the system. Since I have been parked for a few months, that seems unlikely that it would leak out all at once, as I did not see a gradual degradation in cooling over time, and I have a thermostat inside the frig to keep an eye on the temp. I do not have that third party safety protector on it, which measures the temp in the back of the frig and shuts it off if it gets too warm/hot. I can't remember the name of it, but I've had 3 fail so far, so I finally just left it off. Any help would be appreciated. A new one is $5000+ plus installation, and I don't want to go residential as I like to be off the grid without running the Gen all the time. Thanks, Bill

Good info Bob and Tom, thanks for sharing. I plan to have a "professional" in stall it, hopefully they know this stuff as well? 🙂 Thanks

Thanks Bob. What did you do about the flue on the wrong side?

I realize that there is a lot of discussion about replacing the old Norcold 1200 with a residential refrigerator, but if we could please just keep this discussion about: Will the Norcold 1210 Ultraline RV refrigerator easily fit in the Norcold 1200LR space? Is there an alternative propane/electric refrigerator RV model that will easily fit in the Norcold 1200 space, please share that as well. Thanks in advance, Bill

I think my step motor looks like that too. What’s the part number please

Warren, let me know what you decide to get and how it works. I have an 01 Dynasty that looks like it has the same tail lights. If it’s reasonable, I wouldn’t mind replacing them.

All my airbags came with a three-quarter inch fitting that needed to be adapted to 1/4 inch. All my airbags use 1/4 inch to fit the airlines off the airbags.

Yes they are all brass. I got them from a local rubber and gasket business.