DanVickie

hey all, i have good news on fixing my galley fan no power to wires which previously worked. finally changed out bad fan motor, relay and fuse both were good in aqua hot bay. i finally tracked down more fuses which i originally thought it had to be because of bad fan motor. here is my findings with pics, remember i have a 2006 dynasty 43 king III. one and a half bath. 3 fuses were blown in the rear closet, unmarked, and 2 looked good, i always put them on a meter to check. after i found one and 1 fan speed worked , i figured to keep going on this multiplex . these fuses were on E, channels 5,6,and 7. Thanks to all who helped on this with their knowledge.!!

Thank you gentleman ,!! You guys are awesome. I’ll take a closer look now. I have the low, med, high, one switch above countertop, which did work . As others stated in other posts, it would operate with or without calling for heat, so it would blow cold. i assume cuz of operating from engine loop antifreeze heat too , to heat coach . thank you thank you !!

I have the Aqua hot ahe 100 - 04S. i guess I’ll check relays. I have one above the boiler

Hey guys, very similar problem, changing out fan motor for Aqua hot under kitchen sink, no power down there . Old one was making noise and finally quit, then after a couple hours , I tried old one and new one directly to battery to be sure, old one started for a few seconds , new one fine , works . Checked fuses everywhere with multi meter , all good . Have not checked relays tho, which ones do I check ? , I see a bunch in the back closet, have not seen one in wet bay as you did , but will check again for sure. Fuse in wet bay above Aqua hot good. Thanks for any help.

Hey guys, very similar problem, changing out fan motor for Aqua hot under kitchen sink, no power down there . Old one was making noise and finally quit, then after a couple hours , I tried old one and new one directly to battery to be sure, old one started for a few seconds , new one fine , works . Checked fuses everywhere with multi meter , all good . Have not checked relays tho, which ones do I check ? , I see a bunch in the back closet, have not seen one in wet bay as you did , but will check again for sure. Fuse in wet bay above Aqua hot good. Thanks for any help.

Awnings : 15-20 mph. The automatic wind control set at 22 mph. I think it’s a little high tho , I lowered mine to 18 mph

Hi all, I grew up in LaCrosse WI, on the Mississippi River. Beautiful river road up and down from there. Worlds largest six pack of beer, recently redone, DavesGuitar shop, one of the largest personal guitar collections, parks, lots of live entertainment .Much more !!

This is what came in ours. The display has gone out, but everything else works great. previous owners said they didn’t use it much

Ours came with stackable Bosch , working well, wouldn’t want any smaller. We live in it however too. it is 220 however See above

I copied and pasted this from the Amazon site under The Lucas hub oil , this is not me, my comment is at the bottom, “maybe we shouldn’t use this .” although I use some of their products and like them

Not sure if we should use this , seems real thick according to this research . Nearly 4 times .

I know I have some Lucas 75/90 synthetic gear oil I used before, there is another specific hub oil ?

Thank you, that’s what I was guessing , maybe more ,

I’m just wondering about how much oil these take if I change the oil ? Can’t seem to find this anywhere . Any help on this appreciated , and how to do it. Thanks. 2006 Monaco Dynasty 43 king III

I also have two of these, silent plus, not so silent, tecma toilets . About to clean the blades soon to see if it gets quiet. Otherwise , occasionally it doesn’t refill after flush. Thanks for the info !