Les Hurdle

Many thanks......... I looked at that, but I think the issue is a little further 'out'......... the flooring guy will come and take a look. L

Many thanks. I don't see enough room for that. How does one get underneath the inner part of the slide when it is extended? L

HI Folks... slightly different scenario. I had the floor of my 04 Cheetah removed [incl tiles] and a floating wood floor put in it's place. It is great. However I notice when the slide comes back in [or maybe goes out] something is dragging on the new floor scratching it badly. Hope you can see the lines across the plank in the pics. I tried to look underneath by briing the slide in until it tipped up but can't see or feel anything. Is there a way to get to the bottom of the slide?

Hope I'm in the right area.. I usually get it wrong. My drivers side rear hydraulic jack does not go all the way back up. Fixes/reasons please Les

file off the offending 'tit'. Les

Doesn't Bargman ?? have replacements? I did call them but after being on hold for 40 minutes I gave up. Les

Hi One and all. Reading nfo here I guess my slides do not ave rollers since the drivers side tends to stop st an angle. However, I enclose a picture since the front end of thr slide when 'at rest' seems to allow for the gear teeth so sit on the aluminium support. Is that ok? Les IMG_6322.jpg.pdf

Hi Joel, I may have someone who can help you Les 661 304 6556

Hi Daniel......... do you have part numbers, where to buy etc please? L

Hope you can see the pic enclosed. The corners of my slides have had some 'fabric' added at some time. It is now shot. Anyrecommendations as to corner pieces which can be bought or re-manufactured via something else? Les

I will have one unit plus a working rear o/s penguin which is working ok.

I old like to get replacements for an 04 Cheetah, plug n play? L

Hope I'm not mixing apples and oranges here [apparently I do] My generator sits in the front on rails and was a PITA to move in and out. Cleaned up the rails, much better. The [electric?] slides always seem to grind and bump along. The rollers look like they are coated with old lubricant as do the gear racks. What is; Best way to clean goop off and then which is the best lubricant to apply to everything? Thanks one and all for the info L

has anyone tried these? https://www.homedepot.com/p/Everbilt-Drill-Pump-Kit-PUP63-HD/204667248

Hi Greg, Thanks for the input. That is really good news, but also leaves me questioning. My passenger windshield broke from the bottom of the right hand corner. If the dash does little to assist windshield strength, what would have cause the 'stress' in order for the windshield to break. I was assuming the 'was tight on the windshield and as such going over a dip or bend pushed up hard against the windshield. Hope would the cap cause stress? I'm still wondering, is the windshield best if NOT attached to the dash cover [or maybe loose] so there are no hard contact spots. Hmmm Les