Flyinhy

I will do another re-weigh this weekend. I should have done it earlier but I encountered another problem on the way to the camp site. I'll install a new pressure regulator since I'll finally be able to spend more than an hour or two at a time working on it. The little bit I added to the tag pressure made a huge difference.

So I drove about 130 miles with tag at 40 psi ....drove ten times better. I adjusted to pressures to your specs. And yes, you're right 13k on the steer. Now I just have to figure out why my alternator quit charging half way.

I've been following your advise quite a bit. I can't imagine loading 9k worth of stuff inside this coach. Why is pressure so low in the tag? I was under the impression that low air pressure was not good for these tires.....I'm about to move her back to the job site my apartment lease is up next week so everything is turning out as planned......fingers crossed ..... Yes...14 on the steer

I finally had a chance to weigh my coach today. I filled the fresh water tank and filled the diesel tank. The lp tank is 85% full and I have just about everything I need loaded. The steer came in at 11500, the drive at 22460 and the tag at 3000 ( 35psi) .....the tag behind the drivers seat indicates the coach weighs 46k......what am I missing? I inflated the steer to 95 the drive to 95 and the tag at 90......

Congrats on your purchase! I'm a newer owner of an old coach too and for what it's worth, make sure everything is "roadworthy" first . Tires, engine, wheel seals, brakes......Tires were my main concern.....After several months of basic repairs , I'm finally ready to tackle some if the "upgrades" you mention.

The idea of loading and unloading a Harley out of the bed of a truck isn't my idea of fun but I see now there have been advances in technology. I like the self loading ramp. I never even thought about that. Another question is a supplemental braking system......I've never towed anything but a cj5 flat before.......is a braking system necessary?

I've been considering buying a car hauler for my coach. I have a sterling tow bar that was on my MH when I bought it along with a base plate for whatever vehicle the previous owner had. I really like the idea of flat towing my 2016 gmc sierra but I also want to be able to take my motorcycles when I want. What about tire wear on my truck? A car hauler would fit the bill with a little modification adding a motorcycle ramp on the front. Is anyone else just using a trailer instead of flat towing? The truck weighing roughly 5200 and a trailer weighing 3600......that's a lot of strain on a 20 year old engine and trans already pushing 46k down the road. I just wanted to get some input on some ideas.

John, did you ever find your diagnostic port? I remembered reading this today and I just happened to find mine under the dash tucked up to the left of the steering wheel. Yours should be similar to mine. Trans, engine and ABS are mounted right beside each other. I also have a port in the engine bay too. Hopefully your new mechanic will get you on the road soon.

My coach has Bose surround sound throughout. The bass is under the sink and speakers outside in a lower bay....but I have NO clue how they turn on......I have a remote for it but it's not turning on anything. I have this satellite thingermabob...(technical term) in the overhead front cabinet with all kinds of wires going to it....counting all of the video, tv and elec remotes earlier.....9 total.

Spot on. Ace hardware had it. 25 bucks but hey, it's fixed now. I hope other people with older coaches read this post and look at the pictures .....I got lucky. I could have easily had a huge fire. 240v aching inside a fiberglass and wood motorhome is a rolling bomb. If I was rolling down the road and had everything turned on and she caught fire.....I wouldn't know it until it was too late.

And you put a reman/refurb in right? Be on the lookout for a spare....lol Good job 👏 👍

My nickname isn't "hard luck Chuck" for nothing...... I did.....I just finished. The only breaker I didn't replace was the 50amp single....I couldn't find one. I will just leave it off for now.

Man!!!! Lucky isn't the word for it.....Found the same box at home depot. 68 bucks....easy swap. The 50 amp single is for the floor heater.

A few of the other breakers look bad. I'm just gonna replace the whole box. If you look at the contact strip on the box itself , it's been arching for a long time. Half of the contact face is gone

Well.....I finally made it home and the MH is really cold inside. I opened the electrical box and took breakers out to find this home depot....here I come!

Considering everything they did , that's not too bad. I'm sure the parts alone were 2000.

Update.....I had a few hours last night to go home due to the weather. I did what you guys suggested and cut all power off at the main box in the bedroom. When I cut everything back on I heard the "crackling" again..... I shut it down then took the main fusebox cover off and tried it again......sparks galore! The breakers are arching to the main strip. Several are discolored on the backside. I will be replacing all of the breakers and all of the original outlets. Who knows what could have happened if I would have left the coach plugged in all week.

Ugh.....dump trucks with those magical bouncing rocks

Yea.....that's what I was thinking. That's not good. Your rocker arm bolts are all loose? Head bolts are tight though right? It looks like you have metal on those threads. Without trying to crank the engine , I'd spin the engine over with a big ratchet and check my valve lash. I'm not sure what engine you have ....5.9?

The headlights look great. After spending 5k on tires , I'm on a pretty tight budget for now so I'll have to use the old lemon and baking soda trick to clean up my dingy headlights. 😁 I think they're from caddy sevilles? Like 98-2003?

That sounds more like it. On the older mechanical 5.9.....pressures were 20k. I don't think it's an underlying issue either. Again....good job!

Awesome job! You're the man!! What's the actual pressure on that rail supposed to be.....just curious

I've been working on the coach for a few weeks now and I had a question about slide parts. The bedroom slide switch has been bypassed and it's now located on the bed slide itself. I have to unlock the motor everytime I slide this thing out. Looking at the schematics and then looking under the front part of the bed....there's a circuit board that's been bypassed. Can you still get these parts? I guess I'm old fashioned and I like things to work the way they were designed to work. Just wondering if anyone has had to replace that board before.

So, what you're saying is......I need more than one fire extinguisher? 🔥

Esco.....I'm just assuming this was the replacement for the IOTA. Looks pretty new. The invertor was replaced 11/2017........ Several outlets are missing and the one for the microwave is sketchy at best. Funny you say that about mice.......Alvin or one of the chipmunks had taken up residence in the rear bay where the water tanks are....but I haven't seen any damage.