Venturer

I decided to remove just the top edge below the windshield. That is the only area that was pealing. It is about 1-2" wide and tapers to nothing at the sides. A Blow dryer and plastic chisel from Harbor Freight made for easy removal. The hardest part is getting the glue off, but patience and Goo Gone seems to do it. The rest of the front is fairly good yet.  It's not as nice as complete replacement, however, I won't have to look at the pealing film every time I walk by.   😎  There is some checking on the upper panel between what I have done and the top of the generator slide out. The film comes off fairly easy while holding a hair dryer in front of the chisel and slowly pealing it off. Plus, I found the glue comes off easier if heated and rubbing it in with my fingers. I can see doing that panel some afternoon when I get bored. It sure beats paying someone else $150 or more per hour to do it. 

The new keypad came, and it works like it should. 

OK Thanks

After setting the tank levels, the Grey seems to work, however, the Black and Fresh are erratic. I will look into the Seelevel sensors.

I think the MH Gods are smiling on me. I was contacted by PM from a member who has a Tru-Center unit with about 6 months use before he removed it when trading coaches. He does not need it and very graciously offered it to me. Just have to get it from east TX to Lake Havasu. All days are good, but some are a little better. 😀    

It turned out to be the Hi temp sensor according to the tech. He has ordered one which should be here in time for a trip to Quartzite. If not, he will switch the wires with the other electric one for the time being. Guess I'll know in a couple days. Thanks amphi_sc for the suggestion.

The wet bay is dry this morning. All of this frustration because someone pulled the vent tube out of the exit hole and forced it up over another tube at the top of the black tank. I can see no reason for doing that. I couldn't see it till I removed the outer panel that held the Aqua Hot monitor. A technician had to have done it while servicing the AH, however, I see nothing gained by pulling the tube up. Regardless of the reason, I'm a happy camper. Now, it's on to getting the fresh and grey tank level sensors working. 

That is what I need. So 12" is the correct length?