Georgia Mike

Yes it was you Bill, thanks for saving me tearing the city/tank valve apart for no reason. I thought for sure it was not seating all the way.

Just a follow up on my water tank filling up. I ended up replacing the water pump and it solved the problem just like Larry. I ended up going with this water pump from Latch.it and so far it has worked great. Even though it’s 3.5 gpm compared to the original at 5.5 its seems just the same output. It is definitely quieter than the old one and it only uses 7 amps max. It only took about 15 min to install so I will see about the longevity of it and it’s a U.S. company.

I had this same thing happen on my previous Motorhome. I went to have it filled and it poured out from underneath, scared the crap out of me. I was very lucky there wasn’t a spark or something to ignite it. I disconnected the old hose and took it to a shop that made hydraulic hoses and they made me a brand new hose with the correct ends matching the old hose. From what I remember it wasn’t to expensive.

Maybe I didn’t clarify that to well. I have the two filters in the wet bay but I pulled them out and added an under sink reverse osmosis system.

Oh, ok I thought they both ran through them. I never really looked at it to closely. I don’t even have filters in mine because I have an under sink filter system.

Have you checked the factory water filters in the wet bay?

I thought it only had a breather tube so where is this PCV filter located. I would like to change it.

No, they are hydraulic lines for the fan. I’m getting two ways of thinking on this issue. Some are saying that if the oil dipstick cap came off that oil will come out and that’s normal others are saying it’s positive crank case pressure from a blocked breather tube. The weather has been raining here so I haven’t been able to check any further but hopefully today I will be able to look further.

So I am on a trip at a campground and noticed oil droplets on the the back of the motorhome. I opened the rear hatch and found oil sprayed on the left side of the engine. I went to check the oil and the dip stick was partially out. I then noticed that all the oil seems to be around and below the dip stick opening. Can oil come up the tube like that? I checked the oil before I left and I always make sure the dip stick is seated back on. Now when you try and tighten the head of the dip stick it won’t seat it just comes out real easy. I guess something is wrong with the rubber grommet at the end or something. I assume as you tighten the head of the dip stick it’s supposed to wedge the rubber grommet? Btw Merry Christmas

Great write up John on replacing the bad relay. If mine ever goes bad and it’s just one of the relays I will definitely use your information to change it out. I would miss the Aladdin system, I use it all the time.

Thanks Stephen, every faucet I have ever changed always unscrewed from underneath. The fact that I can’t see it to well andI can only get my hand under there doesn’t help

I bought two new faucets to change in the bathrooms. I believe these are Moen faucets that were original. Has anybody removed these? I went underneath and and puzzled how this thing comes apart, not like a standard house faucet

Did you double check the roof running lights? They are a prime suspect's. On my previous Motorhome I had the same symptom of water leaking on to the dashboard and I went on the roof and checked but couldn’t find anything then I saw some moisture on the inside of one of the lenses. It was hard to see but that ended up being the problem.

I went over today to double check some things because it’s getting down to 24 here in Georgia tonight and the ABS light does come on for a few seconds then goes out so I assume the ABS system is functioning correctly. As I said previously if the ATC system was malfunctioning I would think the ABS system would be affected as well since they are using the same speed sensors. I have seen people talk about an abs board but not sure if there is an atc board. I looked in the wiring diagrams and couldn’t find anything on either system. I’m just thinking I might be chasing something that doesn’t need fixed but I’m just not sure.

I think someone recently on the site used this product to seal a leak in there Aquahot system. If yours is just dripping it might be worth a try. I tried to find it but couldn’t. I think they said it fixed it pretty quick and it’s been a while and no leak since. https://www.amazon.com/Irontite-All-Weather-Seal-Blue/dp/B002BIZJMS/ref=sr_1_2?crid=2D94NTG6PCQ5J&keywords=Ironite+sealer&qid=1702904462&sprefix=ironite+sealer%2Caps%2C136&sr=8-2

So it sounds like according to my manual that the light stays on all the time until an “event” happens. I agree it doesn’t make sense that they would make the ATC system in the same year act differently between models. I don’t know what to think now. I am getting ready to go on a trip next Sunday and I am going to try and see what happens with the atc light when I press the switch on and off to see if it blinks or goes out or something. I’m also going to make sure my abs light comes on momentarily when I turn the key on like Ivan suggested.

I found this in the owner’s manual about the atc light. I sounds like it’s saying it should stay illuminated at all times and blink when there is wheel slippage or when an event occurs. So I wonder if there is even anything wrong. ATC Indicator Light: During normal operation, the ATC indicator light will illuminate steady when the ignition key is turned ON. If an ATC event occurs, the indicator light will fl ash quickly. The indicator light will fl ash slowly if the ATC switch is activated.

Thanks Scotty, the only thing is these aren’t Flex steel they are Kustom fit which is now Villa. I will check out Tony’s .

We have been looking to upgrade our furniture for sometime. We had a sleeper sofa on the passenger side and two chairs (not original) on the driver side slide out. The chairs didn’t really match to well. My wife found a guy near us selling his furniture out of his 2022 Newmar Essex. It was basically brand new furniture. The slide out sofa has power foot rests that come out which I have never seen before and the other side is a queen sleeper. Both ended up fitting perfectly in our rig like they were made for it. The only problem now is our captain chairs don’t match so we want to get them redone. I’m looking for some recommendations for an upholstery shop maybe near the Atlanta area or I would consider traveling as well.

I haven’t looked for it specifically on startup being since there is so many that come on for a few seconds but I will look next time just to make sure the abs light IS working correctly. Thanks Ivan, good place to start. I change all the fuel filters every year so I don’t think that’s the issue.

No the switch is off. The atc light has been on since I bought it two years ago. I thought I read somewhere that it was supposed to be on but now from what I’m reading it’s not. My abs light came on once while driving but shut off after a while and hasn’t come back on so I assume it’s ok. After doing some reading I see if the wheel sensors are defective or out of alignment it would cause the ATC light to come on but I would think the abs light would be on as well so I am thinking it’s something else since my abs light is off

My ATC light is on all the time it never shuts off. I thought that was normal but maybe there is a problem.

I found this topic about the vertical uprights cracking and went under my Dynasty being since it was made in 2005 and in that range of not having the gussets. If I’m not mistaken it looks like it has them on the backside of each upright. I don’t think this was added it looks original. Am I correct in this?

If you click on the link in my previous post then click on select a topic then schematics and Motorhome information

I just received my build sheet a few weeks ago. I went to the Monaco web sit and put the information in and they sent it to me in a few days. Here is the link, https://www.monacocoach.com/contact-us/