bryan browne

My 2007 was bad also when i purchased it, I replaced it with a aftermarket last year, has worked very well to date.

I have the Dynasty Palace III with a full wall slide on drivers side. It has a swinging door that must be open to close the slide in to the bedroom. I also has you sliding door from the bedroom to the bathroom that has the same floor lock to keep it open when traveling.

I know dometic has some, not sure if they can be retrofitted to your appication. https://a.co/d/0oWo1Q9

I had the same issue last month on a 2007 Dynasty, it was my clockspring that is under the steering wheel, I took it out, removed steering wheel and column cover and disconnected at base of steering column and from steering wheel, check continuity on the wires and they all showed good, put back in and some buttons worked so I new it had a back spot in it, ordered a new one and my issue appears to be fixed.

Mike does your Generator not slide out the front? leaves a nice area behind it when you get under the bus.

Mine is a 10kw and i have looked on the part breakdown drawings looking for the part number for the water temp sensor and have not found it. thought for sure it would have something on the cooling section drawings for location and part number but not there either. Update: I did find it on the thermostat assembly breakdown Page 40, Part # 193-0318, thanks again

Great article and video, I have a 2007 with 10kw, Is there other parts I should carry, I see people ask about thermostats and sensors. I carry filters and a belt but would add parts to have in emergency. thanks

I have 3 a/c's and my middle one is not heating or cooling as the others. I had read somewhere in the past but cant find article that when having 3 that 2 of them that are running off the same themostat there are some wiring that is interconnected. With that the article sited that only a few a/c can be used without major wiring issue. is anyone familiar with this and if so which a/c could i use? I run the Micro Air Easy thouch thermostats . 2007 dynasty

My insurance with progressive jumped also to $2700.00 for a January 30-2024 renewal on my 2007 Dynasty Palace lll. I move it to Secura with my home and vehicle policies. It was a little over $900. with my umbrella coverage also. Not sure what progressive is thinking. Also have a truck listed with progressive on a commercial policy and the new renewal doubled. Shopping that also. Both policies the agreed value was $125k

Somewhere along my 2007 dynasty's life the Alladin was changed to a Silver leaf. All my systems seem to work like engine information, speeds and trip odometers except the tanks levels. I just ordered the see level and was told by them that the seelevel will display on the Silverleaf. Hoping it is so. they did remove the bedroom display for the Alladin and I wish I had it. not sure what diplay would interface without bringing additional wires.

Got a lot of info from you guys again. This time Im less Warm and Fuzzy with changing my 2007 Dynasty to Lithium as I thought I was. I have learn I know a lot less than I though when gthering my materials for the swap. I will keep reading and learning so thanks for your knowledge.

you are correct. i had to open another line and it started to drain. I figure have the cap off the expansion tank would have allowed the fluid to drain out. I even blew into the drain line and it gurgled like it was empty.

I see that but isnt the boiler drain the fresh water and not the boiler fluid? opened my valve on it and it is empty from winterization. my A/H currently works on diesel just not electric.

AHE-100-04S -in my 2007 dynasty, how do you remove and replace the boiler fluid. dont see a drain for it in the service diagram. need to change electric element and will replace fluid at this time. is there a certain hose to remove that is better. I had read prior that you need to pump fluid in from drain as to not trap air?

Prayers and condolences to Rays family and friends.