Garry Donohue

I got mine from Allied. Photo attached. I have a 2007 Dynasty.

Then where would one get a replacement monitor? Thanks

I have a similar problem with my 2007 dynasty. The Sony screen works but sometimes blinks off then on multiple times. Then it seems to fix itself on my whole trip home. So I accessed the dash panel above steering wheel wiggled rca jacks, but nothing improved. Is it my module going bad?

Mine is in the overhead cabinet that’s over the door entrance

Rev Group new owner of Monaco (800) 509-3417

On my 07 Dynasty, I have Allen screws, but they are visible without any decorative caps on them. I know because my one camera keeps shimming down disconnecting the signal. I have to push camera back up into place then tighten set screw with blue loctite.

I hold the bottom portion with one hand keeping it from spinning, and tighten the top part with my other hand.

If it’s the long blue Rivet gun with the plastic catch bowl for the used rivet posts, it will work. You have to really squeeze hard. Don’t let the gun slip, it made a black and blue mark on my arm. It’s at harbor freight. You have to extend the slide about half way out. Then unroll the awning material by hand. Get a thin Phillips screwdriver and insert it into the hole at one end of the awning to hold the tension off. Then unscrew the one screw that keeps the material from sliding off the end of the RV, Then slide the material off to one side. Then use a #11 drill bit and drill new holes into the strip that attaches to the RV. Rivet the strip back on and reverse the process

these are the recommended rivets. Call Albany fasteners at the number on the attached bag. You will have to purchase a rivet gun that will pop stainless steel. I purchased one at Harbour Frieght. I think it was 19.99. It is still hard to pop but it will work.

I’m sorry It was in 2020. I would suggest you call them.

I got mine from rvupgrades.com 3” frosted glass lens. Called (ITC#82130 Lens 3” frosted glass) I ordered 2 cost $12.58.

Same happened to my door awning. A good friend guided me to discover a control box that was defective. I have a 2007 Dynasty so if it’s the same, the control box is located above the front dashboard in the above center cabinet, there should be an access panel two screws get removed, it’s also the access panel to get to the center outside DOT running lights. The controller inside has a sticker with the letter “D” on it. That was the culprit. I eliminated the control box and installed a switch to control the door awning. That control box is needed more if you have other window awnings that operate on power instead of manual operation. If you only have the door awning, then you don’t need the box. Note… This has nothing to do with the main porch awning as that has its own separate controls. To get the awning to retract quickly, I jumped the wires. I can explain how to jump if you think that is the problem. Let me know. Good luck.

I drove from New Jersey to Florida in pouring rain with no wipers, RainX was a miracle. It ended up being corrosion under the smart wheel. Just lightly sanded the contacts and has been fine since then.

Before checking fan, go outside to Aqua hot and look at the indicator lights to make sure that circuit is operating fine.

Where is this gathering? And is it the same time every year? I’m new to this.

Congrats, this is the best site for newbies as I am as well. Good luck and have patience when encountering a problem. Think of them as a learning tool.

My 2007 dynasty has the compressor fuse in the front run box on the right hand side. It’s a larger one, gold color.

I also purchased the inlet Valve(the part the hose plugs into). I noticed the spring contacts were weak so when I put the new one on, it contacted much better. Amazon #015235-024 Eureka standard inlet valve plate. $7.55.

On my 2007 Dynasty, I went to the attachment point where you plug the hose in. Mine is in my bathroom. You will notice a metal band around the hose end that when plugged in, the electrical connection is made. I wiggled the hose as I pushed it into the attachment hole and it turned on. I then saw that the metal band was loose. So I folded a piece of paper and wedged it under the metal band to make it push tight against the electrical contacts. It’s been working fine ever since.

We should keep in touch to exchange Problems/learning opportunities.

Congratulations on your new RV. I also have a 2007 Dynasty Squire limited edition. This is the best site for info for newbies as I just purchased mine in 2019. Still learning ,

That just happened to my Dynasty. The top hatch on the front dashboard right in front of the steering wheel. Pry the buttons off, then two screws, then the box is forward of that hatch opening. One of my plugs simply vibrated out of its socket. Just push it back in.

I was able to get replacement hula skirts from Veurinks RV supply. 616-965-9601

I have a 2007 Dynasty Squire floor plan, I have a 2007 Dynasty Swuire floor plan.

Ok I will check that out tomorrow and let you know.thanks so much!!