ok, when have an 04 Dynasty, with the aquahot 100-2S system. Everything works as it should but blows cold air in bathroom. I know from reading that it probably could be a stuck valve. Anybody ever have this problem? Thanks....
I tow a 2013 GMC Sierra behind my 04 Dynasty and have been up and down the east coast, all thru the west and Midwest and never had any problem with the rock guard. I'm keeping mine...
First thing I would do is be sure your fuel filters have been changed, usually if your losing power. Be sure the air cleaner is good. Also make sure your fuel in the tank is good meaning no "algae"! IMHO, going to Cummins to have them run a diagnostics is an opportunity for your wallet to MT
Gary, you never mentioned what year coach you have. My 04 Dynasty had same problem. Connector where it plugs into smart wheel controller was burnt out...replaced with local parts, ( electronic store ) and works fine.
I found that where the connections plug into the smart wheel controller were dirty. Used electrical contact cleaner and it seem to fix the problem. 04 dynasty
I never let my fuel get below much more than 1/2 before topping off again. You will get water and crap when you let it run low...remember, these are diesels, not gas which can operated on a very low tank...
Right on Chuck, we'll said
188' is not really hot for a diesel. Your speed shows almost 75mph, perhaps a slower speed should see lower water temps. That engine is working hard so the increase in temp. My Dynasty runs at 185-190..
Ok, thank you....will check that out. So, there are 3 zones which mean 3 pumps. I assume the check valves are close to the pump themselves?
Thanks Ivan, you answered my question on where the check valves are...
We have an 04 Dynasty with the Aqua-hot 100-02S heating system. Everything's works fine but the bathroom register blows only cold air. All the other zones work fine. Am I missing a valve somewhere? Thanks
Do you mean the center of the dashboard. I know about the wires beneath the passenger cup holder. There is NO power to these wires. I need to find the control module....
We own an 04 Dynasty with the outside push button pad to lock the entry door or lock the bays. We don't know too much on where to look for the control module. I know the reset is under the passenger cup holder. There doesn't seem to be any power getting to the outside pad. Fuse is good under the driver side outside bay. Can anyone point us in the right direction on where to look for the control box? Thx