KevinH

Do you have an Aladdin system? If so it must be turned on.

Last time I had an issue with my Girard awning I called them and they were really helpful with tech support even though my coach is 15 years old

I wouldn’t recommend the Demco Sentry. It’s not that hard to install but there’s no place to store it when you’re not using it. It came with a bag. But it’s very difficult to get it in the bag when not using it.

I have a Aladdin reset button in the small cabinet.

I have the same set up. My switch only has an up or down . When I fill my freshwater tank I put it in the up position. Also my Aladdin system needs to be turned on or it will not fill. When I hook up to city water I leave it in the down position and don’t really have to do anything it automatically converts to city water.

I just had mine rebuilt I had a mechanic help me pull it out. I had STEERING REPAIR SOLUTIONS, INC (786) 443-2978 https://goo.gl/maps/FNXj8wxQXEPmQPvu8 rebuild it hooked it back up everything works perfect.

Sorry for the confusion. I have HWH air leveling and hydraulic leveling jacks. It’s just me and my wife and we just don’t notice any difference between air leveling and the hydraulic jacks. Plus the jacks take quite a bit longer to raise then the air leveling system.

I have hwh leveling system and never use it . I air level.

I think it’s the temp sensor for the Heliotrope solar charger also.

Thanks Everyone,it ended up being a blown fuse in the rear run box. I replaced the fuse and it started right up. But I still wanted to find out why it did that I started wiggling the wires on the fuel water separator sensor and the engine die and blew the fuse immediately.I unplugged fuel water separator plug and put a new fuse in fired right back up I need to replace my fuel water separator pigtail three wire. I think what happen is whoever replaced the filter prior to me probably didn’t unplug the pigtail and just screw it into the bottom of the filter they just twisted the wires and eventually they shorted out. good thing it happened in my driveway and not on the road. Thanks Kevin

Hello, I have a C13 Monaco just changed out the fuel filter. I’ve done this before with no problems or issues. Before I reinstall the new filter I filled it with fuel just like I’ve done in the past. It cranks over really good but will not start. I have a full fuel tank of gas. Thanks kevin

We never raise our TV all the way up into the ceiling. If it gets warm it won’t come down until the AC‘s been on for a while and cools off. I’m assuming it’s a heat related issue. We leave it down about 2 inches and it never fails to operate. But if we put it all the way up and it gets warm it won’t come down until it cools off.

Paul, put me on the list too.

I agree with sea level I replaced mine two years ago works great

My Aqua hot has a reset button on the outside panel. Sometimes it trips not sure why I usually use a toothpick or a pic. And it comes right back on

This is a picture of mine right after I use the wheel puller it didn’t take much pressure at all. I was really surprised how little of pressure it took for it to release.

I had a similar issue eventually had to replace the clock spring I bought it at Veurinks RV center.

I had a similar problem with our rig. My cooling fan ran wide open all the time for the first two years I owned it. I didn’t know this was not normal until someone At a campground told me my RV sounded like a freight train coming through.I researched it and apparently somebody had reversed the hydraulic lines going to the wax valve. I reversed them and it has never done that again.

My steering box has been leaking for about two years now thinking about replacing it or having it rebuilt does anybody know where I can have this done it’s a TAS855299 WF1

I have two in my TV cabinet in the bedroom also one is for the TV/cable. The other one was a satellite feed from the Roof by the satellite dish.

Thanks everyone, I’m gonna go with the 8800L and the netgear antenna.

Looks like it only comes with a 3 foot cord did you Mount it on the roof?

Hello, I’m installing a Verizon 8800L jetpack. It has the capability of installing two external antennas. I can’t decide which type of antenna I need or works best. Kevin

I spent four hours yesterday trying to locating the hose .cut a lot of zip ties removed a lot of insulation. I know where it goes. I’m gonna have to cut the end off of it to get it through everything so I’m gonna try what Harvey said and fix it myself. And if that doesn’t work I’m gonna pull it all out and do what nosemo Suggested install it back in three sections so if this ever comes up again I will only have to remove either the front section or the back section. This would be a good video for dirty jobs I was covered in dirt and grease from head to toe. Thanks for everyone’s help I will let you know the outcome.

I haven’t traced it all the way from the front to the back but I wonder if it’s one hose or it has a splice in it.