Yes, @pwhittle connected to the rear J1939 (9-pin) port by the engine. The J1708 (6-pin) port up front didn’t get a reading. He is going to send you the engine report. We never got the ABS to pull a report.
I have two extra sets of Fleetgard fuel filters. That’s an “easy” swap to try with virtually no negative consequences.
We did try to read the ABS module this past weekend with the Cummins Insite / Bendix software, but couldn’t get it to connect.
Guess I’ll go start twisten de knobs, flippin de switches, and pressin de buttons.
Van,
I’ve searched both the old (Yahoo) forum and this one and can’t find anything newer that ‘09. The only places I’m aware that would have the correct ride heights are Josam’s and Source Engineering. (I’m sure there are others, just not that I know of!)
If we can locate a copy (even paper) I’ll scan it and get Frank to add it to the files.
If you try to to remove the “doghouse” under the center dash to remove the tile and install new flooring, just be aware that Monaco typically put screws down onto the floor AND up into the bottom of the dash.