Gary M

Depends on what style I have. This is for my 09 knight.

Regents run about every 100 hrs of operation.

I spent $1500 to have mine done.

Mine had a loose connection for the toggle handle. I had power to it but if I remember the ground needed tightening. If u need a new switch, check out the following website. She makes new upholstery for the Flexsteel captains chairs and carries some parts. https://www.burnsautoupholstery.com/contact

Here is another source.

Do you have one in your wet bay? Some have just used a 40 or 60 watt drop light for heat. Here is a pic of mine of which did not work till Tom Cherry told me about the easy fix. He has a write up in our downloads. I had to later replace the snap disc though. They are about $300 if you can find one.

Do they have a clear for walls? Haven’t found any yet!

I am no help with your issue, but as far as the space in your post, I found if I notice the space, I go back and do a small edit and save it goes back to normal. I think Scotty was working on it but with his wife sick ( prayers) he has that as a priority.

What Ivan said. Clear for the outside walls. There are areas for white and black depending on your coach. Stone Vos has a caulking seminar. You might call them for the link as I cant find it.

Yes I probably could except my hands don't function like the used to when I was 40 on the boat. And if I were to try, I would need a sheltered place to park for a length of time to slowly complete the project. At this point in time it would be easier to assist someone or just pay to have it done. But I appreciate the thought.

I had similar issue when I purchased my coach. Mine had dry rot in a small area. You have to determine whether it just delaminated from the metal sub structure or it is dry rotted and the 3/8” ply is separated. I lived on a sailboat for years and would find dry rot where fresh water had penetrated the oak ribs. It has to be completely dried out, then inject “Get-Rot” into the wood. Once saturated I used a jack and wax paper in between slide bottom and boards to put upward pressure for 24 hours to set up. Then recaulk. Of course I still want to have Guardian Plates installed by Talin if I ever make it to the east coast.

Many many prayers for the both of you. Gary and Joyce

Well it plugged at 36k. But I think maybe two previous owners may have either idled too much or drove too many back streets. Not really sure. I bought it with 29.5k in 03-2017 and now am at 58.5k.

Mine plugged up two years ago. Was towed to my destination and limped into the RV park. Got a local mechanic to remove and take it to a shop to clean and bake then reassemble. $1500

Mine ran with no heat. The snap disc is what sends power to the heater once you give it power at the convenience center. So maybe its an issue. I recently replaced mine.

There is a write up in our files.

Jones Creek RV Storage in Grants Pass, Oregon. New Facility!! (541) 631-0804

https://bluefire-llc.com/store

For third year in a roll, Wish that was me too.

Very good. If you need any other help you can always call. My bushing is wearing for being only 13 yrs old. That will be my next fix. My handle actually broke from being so hard to open.

I just fixed mine. 09 Knight. Yours is probably different from mine though. From start to finish it took me about 3 hrs.

Your probably right. Not only could the spay nozzles be clogged but also usually under a sink is the anti siphon valve that could be clogged too. In your case you probably have two. Mine is directly above the wet bay under bath sink.

What Ray said!!!

Yes I did! Lisa has the patterns from 2000 forward.

I just paid $795 for my Flexsteel cover.